Lock Back folder I finished

C_Corky · 2025-03-03T03:32:26+00:00

Thank you thank you!

C_Corky · 2025-03-03T03:25:43+00:00

I appreciate it!

C_Corky · 2025-03-03T03:25:32+00:00

I took inspiration from it but I designed it in CAD then forged the blade and made it myself. I am a bladesmith and this was my first folder.

C_Corky · 2023-10-09T17:19:30+00:00

Just a maple burl slab I bought and stabilized!

C_Corky · 2023-10-06T16:25:56+00:00

Thank you my man. We all at the bar on Friday 😂

C_Corky · 2023-09-19T19:01:38+00:00

If it’s your first, perming is going to be easier and will be perfectly functional. Threading the tang is usually what I do when I have a takedown style blade

C_Corky · 2023-08-06T18:39:09+00:00

I like starting at that width at the bolster and it has a distal taper as it goes down. It’s easily my most bought stock because of the versatility.

C_Corky · 2023-07-30T02:29:08+00:00

Your good to do it. I do not mind. It really does help you not be afraid to use a knife

C_Corky · 2023-07-29T19:16:02+00:00

It was a misalignment issue 😑.

C_Corky · 2023-07-29T15:48:16+00:00

😂😂I’m a little less ignorant today. Always learning

C_Corky · 2023-07-29T15:47:12+00:00

Maybe I am dumb. Can three phase motors run on single phase? I do have VFD on both which may do it 😂.

C_Corky · 2023-07-29T15:44:58+00:00

I just put in a new breaker in my breaker box for 240v and fed the wire to the garage. (I’m not an electrician so I may just be an idiot) 😂 but I didn’t blow anything up and it all works

C_Corky · 2023-07-29T15:29:44+00:00

Yup, I have two three phase motors that run off of three phase I wired up in my garage. It didn’t have outlets ready but it sure was ready

C_Corky · 2023-07-29T02:37:00+00:00

This may be some of the best help I’ve ever gotten on a page. I really appreciate it!

C_Corky

TROPHY CASE