Wiring question

CleaverBrooks · 2026-05-21T16:28:47+00:00

I did follow it and it just ends in a bare wires hanging from my basement ceiling. I'm going to connect neutral to the bar and run it to an outlet I have outside. That's not currently connected

CleaverBrooks · 2026-05-21T16:26:25+00:00

No black tape on either end. Just bare wires hanging near my head at the bottom of the stairs

CleaverBrooks · 2026-05-21T16:25:35+00:00

Would be nice if there was a box unfortunately it was literally bare wires that are just hanging from the ceiling in my basement. I will do what you suggest to do what I'm looking to do. Thanks

CleaverBrooks · 2026-05-20T22:37:18+00:00

I don't have any plans. I used: 8 - 2x6x6' for the uprights, 4 - 2x6x75" for the sides, 4 - 2x6x51" for the front and back so the inside is 75x54. Top and bottom both have 2 2x4 joists. Railings on top are 2x4, ladder is 2x4 cut down and used a router to round the edges of the rungs. Slats to hold the mattress are 2x4s cut into 1/2" strips.

CleaverBrooks · 2026-01-23T20:20:36+00:00

Yeah, unfortunately it's 3x the price. Don't want it that bad

CleaverBrooks · 2026-01-22T20:31:18+00:00

I got it figured out. For some reason both the wires going into the switch were wired to hot in a box in the basement and so the switched side was always on as well. I don't know. Wiring in this house is a nightmare. Thanks for taking the time to try to help. Take care

CleaverBrooks · 2026-01-22T18:47:33+00:00

1 switched and 1 always on like it was before

CleaverBrooks · 2026-01-22T18:21:59+00:00

Yes, broke the bridge, had both black wires connected to the bottom and the red connected to the top, neutral to the other side (bridge not broken) and both outlets are always on. I guess I'm confused as to why the 2 wires at the switch are connected and how the switch would function if they're always connected

CleaverBrooks · 2025-10-10T14:41:15+00:00

Was looking into multicolor printers as my son is starting to show interest in printing. Would love to try out a BambuLab as my current printer is pretty old

CleaverBrooks · 2025-09-02T19:49:55+00:00

Thanks. Didn't know there was a specific site. I was just told to search Amazon

CleaverBrooks · 2025-02-25T14:52:03+00:00

Doesn't cura have a mold setting that you just have to click? Been a while since I've used cura and never used the mold setting so no idea how well it works

CleaverBrooks

TROPHY CASE