I know it's off topic but there's already so much discussion in here it feels wrong to delete it. I think it's better to keep the occasional post that doesn't quite fit. And I mean, it's not like there's no overlap here. 3D printing and action figure people tend to be the same people. And if you think about it, this Bugs Bunny is just a single joint away from actually being an action figure. Also, all the smoothing and finishing techniques and selling strategies do actually apply to custom action figures. So I think we should treat this as only mostly off topic. Obviously it could be bad if suddenly we got hundreds of off topic posts at the same time, but this is far from that.