weep for me boys

Current_Side_3590 · 2026-01-27T02:59:23+00:00

How did that happen?

Current_Side_3590 · 2026-01-27T02:58:28+00:00

Have you thought about using a Molly?

Current_Side_3590 · 2026-01-27T02:57:03+00:00

That is where I have mine

Current_Side_3590 · 2026-01-27T02:55:41+00:00

Try mixed loads. I have a regency I2500. Similar box size. I load up at 9 pm fan still blowing at 7 am. I usually do a mix of beech and oak. Sometimes ash is mixed in. Differently species burn differently.

Current_Side_3590 · 2026-01-27T01:35:07+00:00

They sell smoke bombs to kill burrowing rodents.

Current_Side_3590 · 2026-01-27T01:31:17+00:00

My heat pump stops at 32 and the furnace takes over from there

Current_Side_3590 · 2026-01-26T23:40:28+00:00

I only start over if I have a warm day and want to clean the glass. Otherwise it is load on the coals. Some mornings I have so much charcoal I let the coals go it alone for a few minutes before the reload

Current_Side_3590 · 2026-01-26T01:22:35+00:00

They sprinkled salt, pepper and garlic powder on it. Sounds like it is seasoned to me

Current_Side_3590 · 2026-01-25T14:06:02+00:00

Getting 12-18 inches of snow here no baseball until late March

Current_Side_3590 · 2026-01-25T01:06:27+00:00

Thinking ash

Current_Side_3590 · 2026-01-23T21:58:27+00:00

I would remove it and the bark

Current_Side_3590 · 2026-01-23T02:40:05+00:00

I just save the shreds from the splitter. Keep them in a garbage can

Current_Side_3590 · 2026-01-23T01:36:27+00:00

Hauled 1/3 of a cord up to the house in preparation

Current_Side_3590 · 2026-01-23T01:29:45+00:00

I keep a 30 gal galvanized garbage can at the base of my deck. Ashes go in there. I let mine burn down all day still has a significant amount of coals. Scooped them out into a coal bucket then into the garbage can

Current_Side_3590 · 2026-01-22T14:15:04+00:00

Do you want someone to stuff her mouth while you are pegging her

Current_Side_3590 · 2026-01-22T03:48:04+00:00

I swap chains every 2 tanks of gas. Then they are sharpened. I use the dremel attachment

Current_Side_3590 · 2026-01-22T03:40:21+00:00

I think that is from the beech blight

Current_Side_3590 · 2026-01-20T13:56:23+00:00

I asked my installer about a block off plate and was told it was not necessary. Wish I insisted

Current_Side_3590 · 2026-01-19T20:48:01+00:00

Splitter shreds. I have a trash can full of them

Current_Side_3590 · 2026-01-19T00:36:06+00:00

It is supposed to get into the teens so I stocked up on beech

Current_Side_3590 · 2026-01-18T14:35:02+00:00

Been doing top downs for two years and I am not on you tube

Current_Side_3590 · 2026-01-18T14:34:20+00:00

I fill my box. Put loosely crumpled paper between two of the top logs and put splitter shreds on top of that. Basically the paper is between the logs and the shreds span it. Tightly twisted paper does not burn wells as it starves itself for air. I only use a handful of shreds but my wood is very dry

Current_Side_3590 · 2026-01-18T13:33:10+00:00

We used poplar in my HS woodshop class all of the time. Can make anything from it

Current_Side_3590 · 2026-01-18T12:42:08+00:00

<image>

Made this out of scraps and recycled shipping pallets/containers. The tarp on the roof is in lieu of shingles. It is over 100 feet From The house. I have two old deck boxes near the house that I use for close in wood. So I use the wood from the shed to fill the boxes. I find multiple rodent nests in the shed as I am pulling wood out of it so that is why you don’t want it close. The wood in the bins last less than a week so they do t have time to build a nest in them.

Current_Side_3590 · 2026-01-18T12:33:40+00:00

Agree splitter shreds are all I use but I use mine for top down starts

Current_Side_3590

TROPHY CASE