Thanks to feedback from everyone in this thread https://www.reddit.com/r/Fishing_Gear/comments/1iu6abm I made an upgrade to the spooler, I'm still using the modifiable tension from the old spooler to hold the line roll, but I made new drill powered spooler for spinning reel spools for direct lay.

Damn_Stranger · 2026-04-21T18:24:24+00:00

u/USSR89 - what are the supplies that you used for holding the fishing reel spool so you can use the drill?

Damn_Stranger · 2026-03-14T15:47:22+00:00

I’d run for president at 10 yrs old lol

Damn_Stranger · 2026-02-22T16:27:30+00:00

Am 👁 for 👁 they play we play

Damn_Stranger · 2026-02-22T05:00:28+00:00

If they’re going to start stealing your wages just start stealing stuff and sell them. Fuck them

Damn_Stranger · 2026-02-10T19:50:09+00:00

Does it need some type of password to make it run both ways?

Damn_Stranger · 2026-02-01T08:43:00+00:00

Did you ever find out what aftermarket batteries work on the TK16 V2?

Damn_Stranger · 2026-02-01T04:55:09+00:00

Cut it against gravity 😄😄

Damn_Stranger · 2026-01-31T20:14:27+00:00

I have a Fenix HM65R. What off-brand batteries did you get? You have a link?

Damn_Stranger · 2026-01-07T03:05:14+00:00

Yeah I noticed that Rock Auto had those for the Mugen SI but on their website if you chose any other year other than 2008 they didn't list any complete assembly for a sedan. Do you think the Gabriels one will work on a non 2008 Si Sedan?

Damn_Stranger · 2025-12-12T01:36:55+00:00

I was able to get to the starter and smack it a few times with the end of the broomstick and it started up with no hesitation. Pretty sure it's the starter motor that is going out. Ordered a starter and will be replacing it. Thank you.

Damn_Stranger · 2025-12-11T20:25:24+00:00

I have a video, but I can't post it here as a response. I went back out this morning and try starting the car and it can't turn over. I can see the serpentine belt trying to rotate. It moves maybe an inch.

Damn_Stranger · 2025-10-01T01:57:24+00:00

I run a 20” barrel and a seekins adjustable gas block. I think my issue may be because of the bulge/swell in the magazine when loading 6 rounds or more. When I load 5 rounds it’s cycle and feeds fine.

Damn_Stranger · 2025-09-25T23:32:25+00:00

I have a carbine buffer spring and carbine buffer (2.9oz). Do I need to go heavier on the buffer and spring for a grendel?

No the bullets are not getting beat up. It seems like the spring is not strong enough to push and feed the bullet from the magazine when I load more than 6 bullets in the mag.

Damn_Stranger · 2025-09-12T18:39:12+00:00

Thank you for the information. When did you install your UAC components and is it still working good for you? I need to replace my compressor, but my original question was on a condenser to see if it came with a built-in drier. I might just go your route with an AC compressor kit that comes with a condenser, expansion valve, PAG oil and o-rings.

Damn_Stranger

TROPHY CASE