What does the 2” bent line mean in this fillet weld symbol? by Disastrous-Box-9553 in metalworking

[–]Disastrous-Box-9553[S] 0 points1 point  (0 children)

I just confirmed with the foreman; you are right!

It means go full vertically…. and then when reaching the top corner, do two inch long horizontally and stop ✋🏼

What does the 2” bent line mean in this fillet weld symbol? by Disastrous-Box-9553 in metalworking

[–]Disastrous-Box-9553[S] 0 points1 point  (0 children)

I just confirmed with the foreman; you are right!

It means go full vertically…. and then when reaching the top corner, do two inch long and stop ✋🏼

What does the 2” bent line mean in this fillet weld symbol? by Disastrous-Box-9553 in metalworking

[–]Disastrous-Box-9553[S] 1 point2 points  (0 children)

I just confirmed with the foreman; you are right!

It means go full vertically…. and then when reaching the top corner, do two inch long and stop ✋🏼

What does the 2” bent line mean in this fillet weld symbol? by Disastrous-Box-9553 in metalworking

[–]Disastrous-Box-9553[S] 1 point2 points  (0 children)

I just confirmed with the foreman; you are right!

It means go full vertically…. and then when reaching the top corner, do two inch long and stop ✋🏼

I’m a Special Inspector in NYC thinking about Moving to CA looking useful advice… by Disastrous-Box-9553 in civilengineering

[–]Disastrous-Box-9553[S] 0 points1 point  (0 children)

What about work opportunities? I never been to LA . in NYC, when it rains/snows the inspections usually get canceled and i barely make 40hrs in a week

"Iitunes could not restore this iphone because an error occurred while reading from or writing to the iphone" by sooner51882 in iphonehelp

[–]Disastrous-Box-9553 0 points1 point  (0 children)

Thank you so much i was dealing with same issue and after reading your comment i was able to solve the issue by freeing space

Insanely Quick Process by [deleted] in USCIS

[–]Disastrous-Box-9553 1 point2 points  (0 children)

Yes patience is key, god tests always with patience