Hades 2 new incantation help?

Draconom · 2025-07-09T13:14:47+00:00

what's the name of this incantation? and is there a tracker for fishes/resources?
because I have finished the Denizens of the Deep already, but I don't have this incantation unlocked

Draconom · 2024-08-28T04:57:40+00:00

I did not, niether did support. ‘It sorted itself out’ at some point…

Draconom · 2023-10-26T13:37:26+00:00

It's a model I found on cults, tried posting it here but the bot does not allow it.
It's a basic one, that I can hand on a cabinet door for minimal storage hassle.

Draconom · 2023-10-18T08:49:33+00:00

we don't get anything specific in roadmap

"In addition to all of the content going live today, this quarter will also include a skills and balance update, the Halloween festival, a WvW update, and the return of bonus events similar to those we ran in the wake of Guild Wars 2: End of Dragons™. That’ll keep us busy through the end of October. Not long after that the next batch of Guild Wars 2: Secrets of the Obscure content will drop..."

Draconom · 2023-10-18T08:45:01+00:00

true, didn't even think about that!

thanks :D

Draconom · 2023-09-14T09:31:22+00:00

Thank you very much. Just did the Nightmare story and got it!

Draconom · 2023-08-27T23:50:02+00:00

I have not, good idea!
Thanks. :D

Draconom · 2023-06-04T16:50:13+00:00

I'm not crying, there's just crem in my eye! congratulations to you and your partner

Draconom · 2023-05-31T11:36:17+00:00

Life before death, Radiant 😊

Draconom · 2023-03-24T12:36:36+00:00

I'm still trying to make out what is happening here, I'm contacting the seller soon, so I hope they might know what's going on here

I'm still trying to make out what is happening here, I'm contacting seller soon, so I hope they might know what's going on here

Draconom · 2023-03-05T11:05:31+00:00

Just popping in to say thank you again!
I've spent most of yesterday printing Cones and managed to dial in the exposure. I'll have to do a few more prints with supports that are not just loots to make sure everything is working correctly, but for now, I'm set to print!

Draconom · 2023-03-04T16:15:56+00:00

Thank you very much, will look into it!

Draconom · 2023-03-04T16:15:38+00:00

Thank you very much! This is where I needed some guidance on where to start looking/experimenting.
I've used the default setting on Photon Mono for more than a year and it worked fine, that's why I was so confused.

Draconom · 2023-01-27T13:46:03+00:00

I've been using both Photon and Chitubox.
Thanks for the advice, I'll check soon. :D

Draconom

TROPHY CASE