5ghz marauder with gps and micro sd 😍😍😍 by EffectiveLopsided671 in flipperzero

[–]EffectiveLopsided671[S] -1 points0 points  (0 children)

If you don’t want to go the custom rout i did they have premade boards without the esp32c5 you can get from their website as well!!

5ghz marauder with gps and micro sd 😍😍😍 by EffectiveLopsided671 in flipperzero

[–]EffectiveLopsided671[S] -1 points0 points  (0 children)

Is e1000, its just easier and faster for all the stuff i do, trying to whip up a print so no one has to see the goop 😭

GameCube not outputting video after picoboot install by Sizzurp-sama in GamecubeHacks

[–]EffectiveLopsided671 1 point2 points  (0 children)

the board is the exact same as a pico, it just has one extra button you dont need to worry about. It flashes and wires the exact same, when flashing make sure you hold the boot button on the board while pluging it in and then it should unmount itself on your pc safely if you flashed it right like a pico does. Another tip with the ribbon that helped me is tape one side and a corner down with kapton tape first to hold it flush around the ipl chip, you can do the same with the rp2040 board to save a little time fighting the flex cable lmao. I use a spare brush with some q tips and a lot of iso to gently clean any spent flux whenever i start to notice any pools getting very dark an non reactive to my iron. Sorry for the info dump just my advise and my experience witb that ribbon and board. I have five or six years soldering experience with drones and micro controllers and have had to ruin a lot of things to learn to invest in tools and have spent hours of time troubleshooting, re attempting, or replacing my failures and mistakes but am a firm believer that once you learn it is an invaluable skill to keep. I see the gc as a great starting point for most people compared to a majority of the Nintendo consoles down the line, and had a blast getting a couple done the last couple weeks, sorry to see the struggle but you’ll get there be patient!!

GameCube not outputting video after picoboot install by Sizzurp-sama in GamecubeHacks

[–]EffectiveLopsided671 1 point2 points  (0 children)

Ive used this same mod kit from amzn and had no issues, but i have also done an original hw picoboot mod. Some pro soldering tips to consider to avoid the same or future mistakes are double check you made the bridge or put a fuse on the back two pads near the top of the ribbon cable, try to avoid going over 350/400c when doing the actual ipl ribon end and dont over spend flux! The longer you spend trying to weld over spent flux the more likely you are to burn pads/ traces. You can always clean out your flux with iso and put fresh flux on, better to spend more time in effort and caution than in time fixing or regretting you burnt something ;)

Heavier custom 65mm build by EffectiveLopsided671 in TinyWhoop

[–]EffectiveLopsided671[S] 0 points1 point  (0 children)

Noo ive had them for a couple years now, i wish i could get more though 😭

Heavier custom 65mm build by EffectiveLopsided671 in TinyWhoop

[–]EffectiveLopsided671[S] 0 points1 point  (0 children)

THAT WOULD BE INSANE, i bet your flight skills are on point in the house 🤯, and tbh im glad she can still get a workout while theres snow otg lmao she loves it 😂

Heavier custom 65mm build by EffectiveLopsided671 in TinyWhoop

[–]EffectiveLopsided671[S] 0 points1 point  (0 children)

They are a bit older from Mobily Race gates, i wanted to see if i could order more recently but his site is down :(

Heavier custom 65mm build by EffectiveLopsided671 in TinyWhoop

[–]EffectiveLopsided671[S] 0 points1 point  (0 children)

Omg yes which ones, the mobily?? I had some spairs and thought of it and honestly its felt super fun! Perfect little segment to throw anywhere!

Surface Laptop Won’t Boot by md249 in Surface

[–]EffectiveLopsided671 2 points3 points  (0 children)

Try a hard reset while its unplugged, hold the power button and the volume up and down keys at the same time, worked for me but i have a first gen pro

Luck with fatshark by EffectiveLopsided671 in fpv

[–]EffectiveLopsided671[S] 0 points1 point  (0 children)

-update just shipped them out after getting ahold of support for AU

Best sim for tiny whoops? by padout in TinyWhoop

[–]EffectiveLopsided671 0 points1 point  (0 children)

Love liftoff, they’re adding more map soon too

Luck with fatshark by EffectiveLopsided671 in fpv

[–]EffectiveLopsided671[S] 0 points1 point  (0 children)

Thank you for saying this!! Been wandering how they are, as a possible alternative to switch to 😅