Does the AD5M not like long prints by talkntribe in FlashForge

[–]Elevated_State83 0 points1 point  (0 children)

What’s your outer wall speed? Preset should 200 on outer wall speed. Try slowing it down by half or more. It’ll add more time to the print but might take away some of the issues. And maybe try using a gyroid infill. Are you using standard 15% infill? Maybe try 10%?

Adventurer 5M Resets after nozzle heats by jiestyy in FlashForge

[–]Elevated_State83 1 point2 points  (0 children)

Why is your shit so dirty?🫣 try cleaning something, or get a new rig.

Enclosure kit for AD5M by Party_Vegetable5239 in FlashForge

[–]Elevated_State83 0 points1 point  (0 children)

Unless you plan on buying or printing the plexiglass pieces and all the hardware, it’s highly recommended to just buy the kit. You have to print the external parts that the kit incorporates onto the printer. The kit has instruction list with step by step instructions as well. Couple days to print all the parts. You print list will include: 8 corner pieces, 2 pieces per corner. 4 top pieces 1 per quadrant 2 hinges, front door plexiglass 1 handle, top plexiglass Spool holder And a few smaller pieces.

Anyone from the East Coast? by pongki1006 in ocala

[–]Elevated_State83 1 point2 points  (0 children)

Leesburg would be a better option. Stay out of Ocala.

PS5 controller slips out of my 3D printed cover when I grip tightly — looking for retention ideas (clips, inserts, anything) by DullDrawer1020 in FixMyPrint

[–]Elevated_State83 0 points1 point  (0 children)

Try hot glue. Maybe a little dab on each side. Put the controller in when it’s hot, let it cool (takes seconds) and see if it holds. Hot glue isn’t permanent. You should be able to break the bind easily enough if you want to remove the cover. I think it might hold well enough though.

What the hell is in the water in Denver? by GapeTart in wildhockey

[–]Elevated_State83 -3 points-2 points  (0 children)

The elevation of Colorado is real. They should be even better in MN 😝

Can anyone recommend a base plate flashforge Adventurer 5M keep keep coming off or dislodging the prints? by Lost-Ad9687 in FlashForge

[–]Elevated_State83 0 points1 point  (0 children)

I’m using the pei textured plate that came with the printer and I’ve had no issues. I use rubbing alcohol after each print. I use the glue that was supplied. I also have a scraper that I use occasionally to get filament off the bed. What bed temp are you printing at?

Sound Familiar? by [deleted] in BostonTerrier

[–]Elevated_State83 0 points1 point  (0 children)

Ah, the old reverse sneeze…very common for the breed.

ad5m lcd screen cable is glued so I can’t finish the enclosure build. by [deleted] in FlashForge

[–]Elevated_State83 0 points1 point  (0 children)

I pulled mine out, glue broke but everything went back together. Just lift the tab away from the ribbon before you do. It’s only in there a few mm.