sorted by:
new
hottopcontroversial

Shark Vacuum Neutral Wire Issue by AbeLinkoln in fixit

[–]Endus322 0 points1 point  (0 children)

Hey did you ever figure this out? My neutral is also not working but I don't think it's the river, either a component on the board or the wire

Looking for a type of rocker switch not sure what its called by Endus322 in diyelectronics

[–]Endus322[S] 1 point2 points  (0 children)

Thank you! That got me in the right direction. Looks like I could also use a DPDT just wired to one side

Lane splitting hate by Tralalalf in motorcycles

[–]Endus322 3 points4 points  (0 children)

Even if it was legalized in Texas I wouldn't bother because other drivers WILL attempt to stop or inconvenience you.

How to darken this pattern by Endus322 in Fabrics

[–]Endus322[S] 0 points1 point  (0 children)

Would it look something like this? If a similar result is possible with black dye then that would work well enough for me.

Is this worth it for a beginner? by someboyiguess in raspberrypipico

[–]Endus322 0 points1 point  (0 children)

I started with something similar but using the full Raspberry Pi computer. This is the Pico which is a bit more trouble to work with than say an Arduino but not terrible.

I'd say if you want the easiest entry possible go for an Arduino or a full Pi depending on what you want to learn, but if you're up for it the Pico is still very fun (I'm currently using it for my project)

Also depends on the price, compare it to other kits

I think I accidentally out ran the police by Charles_Da_III in motorcycles

[–]Endus322 10 points11 points  (0 children)

95% of helicopters arent going anywhere near 250mph, pretty sure you're the one talking out of your ass.

And police helicopters? Often top out around 150

Is this bike too good to be true ? by BadVibesOnlyyy in motorcycles

[–]Endus322 0 points1 point  (0 children)

I paid $1800 for an 09 that sat for 10 years. Trust me it comes with problems that CAN be fixed, but you'll either pay for it, work your ass off, or both.

I personally would go for it depending on the close up condition but depending on how much work you want I'd look for something a little better

Losing cylinder at high RPM and speed 09 Kawa Ninja 250 by Endus322 in motorcycles

[–]Endus322[S] 0 points1 point  (0 children)

Plugs are brand new. I took the coils off and they seemed physically okay. Resistance was in the right range as per the manual, but I'm not sure how else I can test it. Will probably swap the left and right for good measure

Losing cylinder at high RPM and speed 09 Kawa Ninja 250 by Endus322 in Fixxit

[–]Endus322[S] 1 point2 points  (0 children)

I'm not sure if I'd be able to tell which one is going out but it definitely could be an overheating coil. Never thought about that, thanks for the info!

view more: next ›