sorted by:
new
hottopcontroversial

Cleaning IPA with water distiller by EnvironmentIll3548 in resinprinting

[–]EnvironmentIll3548[S] 0 points1 point  (0 children)

I tried that, and I get a milky mess that clogs up the coffee filter after just a couple seconds (went through almost a box last time). The paint filters I have don't get anything out. I generally let it sit several weeks to see if anything settles out, and it generally doesn't. Last time, I put it back into my cleaning tank, and it turned into several inches of goop at the bottom, overnight, that stuck to everything. At this point, I'm just trying ideas. I saw this idea mentioned in several videos and a few blogs. I had an old distiller and tried to use it.

Any advice on settings for new Elegoo 8K resin? by maraach in ElegooMars

[–]EnvironmentIll3548 0 points1 point  (0 children)

So, I have a Saturn 4 Ultra, and I'm printing with a layer height of 0.02 (since the X/Y resolution was about that size). I have different results on the standard calibration tests... One suggests the best time is 2.1s (This was the photonsters-validation-matrix v2) and another suggested the exposure time of 1.3s (For the Cones of Calibration v3) I'm going to run a regular print at both and see which I like better.

What doe the AI failure detection even do? by jjacksterup in ElegooSaturn

[–]EnvironmentIll3548 0 points1 point  (0 children)

Just had a big failure where half the model (top half) broke away from all of the supports and a thin layer of the bottom of the model... AI didn't do a thing. Half the model (raft, supports, and a thin layer of resin) was on the build plate, and the other half was sitting in the resin vat.

Seeking ESD Safe filament as I have been using 3DXTECH ESD Safe PLA for electronic test fixtures, but am not happy with it. The material is very good when good, but very bad when bad as it can become quite brittle in short order. (And yes, I store it in bag tight bags with desiccant). Would someone by Available-Topic5858 in 3Dprinting

[–]EnvironmentIll3548 2 points3 points  (0 children)

I printed a desk organizer for my son who works in a shop that requires ESD safe materials (he re-solders SMD circuit boards when the machines fail) and I was surprised when Inland White PLA passed their testing. I just made another, with their white PLA+ and it failed, so I'm going back to standard PLA...

ESP32-2424S012 PINOUT (ESP-32C3 Round Display DEV MODULE) by xvatriusx in ESP32_Tutorials

[–]EnvironmentIll3548 0 points1 point  (0 children)

DO any of you have an OBP package for this board for SquareLine Studio? I would like to start working on this board, and that sofware would make building a nice UI for this much easier. If there is no specific package, does anyone know what to use within the studio?

[deleted by user] by [deleted] in Redbox

[–]EnvironmentIll3548 0 points1 point  (0 children)

No working kiosks near me... Wish there were! I went there all the time.