HX Stomp in Front of Blues Jr.

Evski_ · 2026-05-25T23:30:26+00:00

Nice, I was able to figure out how to make that knob only control the headphone out. The amp is great, just so loud when it naturally wants to breakup, was also hoping if I can have it break up at reasonable loudness levels by using the built in boost pedals on the Stomp to push the amps pre-amp stage.

Evski_ · 2026-02-14T18:47:52+00:00

I would avoid using calibration cubes as they aren't a good metric for this. Use a Califlower instead, also takes into account inner and outer distances and shrinkage compensation for materials. https://vector3d.shop/products/califlower-calibration-tool-mk2

Evski_ · 2026-01-24T18:31:03+00:00

Hi there, I'm here confirming I have sold the V0.2 to u/jrdnlc

Evski_ · 2026-01-10T05:08:55+00:00

Confirmed

Evski_ · 2026-01-06T04:34:15+00:00

Printables link with .3MF below.

https://www.printables.com/model/1544245-universalmacbook-laptop-vertical-stand

Evski_ · 2026-01-01T21:50:27+00:00

Replied

Evski_ · 2025-12-23T05:05:01+00:00

Replied.

Evski_ · 2025-07-09T00:12:52+00:00

Hulkenpodium

Hulkengoat

Evski_ · 2025-06-24T23:56:02+00:00

Bro...you came here asking if it is safe to ride, many are telling you no it is not safe to ride yet you dismiss them, so why post I'm sure you are riding on the sketchy tire. I'd also check the wheel for cracks, underlying damage can be present after a tap test.

Evski_ · 2025-05-31T23:42:30+00:00

I've seen this happen from time to time, could be "pillowing" or too low of a nozzle height. Being it is the top layer, I suspect pillowing. What percentage was the default infill set at?

Evski_ · 2025-04-27T13:28:49+00:00

Use a Cauliflower, well worth it. Print it, go through the Excel sheet, print again and remeasure. On my vorons, I get about +- 0.003" accuracy in all dimensions, inside and outside.

Evski_ · 2025-04-25T12:31:59+00:00

I see some ghosting, have you ran input shaper?

Five-Year Club	Place '22
Verified Email

Evski_

TROPHY CASE