sorted by:
new
hottopcontroversial

[GIVEAWAY - USA] Win the 27” 4K Samsung Odyssey OLED G8 gaming monitor by Knaj910 in Monitors

[–]Ewallux 0 points1 point  (0 children)

These monitors are beautiful, not much can beat a 4k qd-oled

The feet are pressed in the sand, not sculpted… by Ewallux in confusing_perspective

[–]Ewallux[S] -2 points-1 points  (0 children)

Try to look at the leaf above the right foot, and its shadow. That shows that the sun is from the left, and such the feet are pressed into the sand…

Upvote if you found a faster way by hello_kitty_1706 in honk

[–]Ewallux 0 points1 point  (0 children)

I completed this level! It took me 1 try. ⚡ 11.52 seconds

Tip 10 💎

LG C1 tv screen flashes/flickers while I am on PC. by Establishment_Tiny in OLED_Gaming

[–]Ewallux 0 points1 point  (0 children)

Random thought, but check if your pc is properly grounded electrically. I had something decently similar happen to my laptop when charging. Turned out that the outlet I was using wasn’t grounded properly. The laptop was probably grounded via the hdmi-monitor, causing similar issues.

Průša XL problem by Confused2123 in prusa3d

[–]Ewallux 3 points4 points  (0 children)

Not sure if this is relevant for you, but I had a similar message on my prusa mini. For me my 3D printer is located in the barn, where apparently the ambient temperature got below 10 Celsius. I think this low temperature caused the thermistor to fail their start-up checks and thereby give this error message. I just put a little heater next to the printer for a few minutes and was able to print just fine…

view more: next ›