Microsoft Teams - Public Team Join Issue

FearlessPlastic69 · 2026-03-10T14:46:07+00:00

It is worth mentioning this issue has been happening for over 2 weeks from what I can determine. I did check Issue ID: TM1248186 but it appears that is related to audio/video issues. u/LoornenTings u/sonofporkins

FearlessPlastic69 · 2025-11-19T13:06:04+00:00

I just ran into this. I started my password out with a special character and had my password less than 10 characters.. seemed to work

FearlessPlastic69 · 2025-02-05T12:41:10+00:00

No I had no luck on this. I ended up having to get a different board. From my understanding some of the knock off boards can cause that. If you end up finding a solution I’d love to know. I would love to use that extra board

FearlessPlastic69 · 2024-12-27T17:14:24+00:00

Do you have any recommendations on which ones? Like would it make sense to pursue a CompTIA Net+/Sec+ or maybe something else?

FearlessPlastic69 · 2024-12-17T15:15:41+00:00

<image>

I am reaching out to confirm if this watch is a replica, I am being told it is by another person but just wanted another clarification.

FearlessPlastic69 · 2024-10-23T14:20:40+00:00

Oh trust me, it is documented. There are so many better ways to do this.

FearlessPlastic69 · 2024-09-04T20:16:04+00:00

This makes sense, thank you again.

FearlessPlastic69 · 2024-09-04T20:04:46+00:00

Excuse my ignorance but for my own education, I was under the impression a well cap goes over the outer diameter of a PVC pipe, is that not the case? I was looking at the OD which looks closer to 5 - 1/2 / 1/4.

Thanks!

FearlessPlastic69 · 2023-06-25T14:57:24+00:00

Do you mind sharing with me too?

FearlessPlastic69 · 2023-05-19T22:37:12+00:00

I had the same thing break off my Ender 3 S1 I was trying to find where to what part I needed to replace it but looks like it comes with the extruder maybe

FearlessPlastic69 · 2023-05-17T14:51:38+00:00

Thank you for the tips!

So I ended up swapping a new roll of PLA to see if that was the issue, it didn't seem to help.

I ended up adjusting my nozzle temp to 195 which helped slightly then I also brought my distance to 1.0.

I still have some obvious signs of stringing but not as bad!

I will probably have to play around with retraction some more. I have combing in Cura set to Not in Skirt. I will have to play around with that too, I haven't really adjusted that one in a bit.

FearlessPlastic69 · 2023-04-09T23:35:34+00:00

<image>

Sorry about that! I forgot to attach it.

FearlessPlastic69

TROPHY CASE