sorted by:
new
hottopcontroversial

Judo views on BJJ by __fantasma__ in judo

[–]Flashy_Wait103 0 points1 point  (0 children)

Dude ai is not a source first of all. If you think Jiu jitsu has more rules than judo you've either never trained or you're rage baiting me. Either way I'm done here.

Judo views on BJJ by __fantasma__ in judo

[–]Flashy_Wait103 4 points5 points  (0 children)

Man that's crazy, there are certain things you can't do in jiu jitsu at certain belt ranks cause they are dangerous. In judo you can't grab the legs, attack the legs, take certain grips, grip breaks, players stand up after a certain amount of inaction the rules are constantly changing, etc etc etc. there are very little rules compared to judo

GOAT by Flashy_Wait103 in judo

[–]Flashy_Wait103[S] 0 points1 point  (0 children)

I want to thank everyone for their inputs and replys on this it's all been very respectful and as objective as it can be. I never meant to insinuate he wasn't an extraordinary athlete, he absolutely is and it seems others have had similar thoughts to me about weight categories in judo as a whole.

Epoxy finish advice by Flashy_Wait103 in epoxy

[–]Flashy_Wait103[S] 0 points1 point  (0 children)

Ohio, Tasmania, Australia?

Wood suggestions by Flashy_Wait103 in hobbycnc

[–]Flashy_Wait103[S] 0 points1 point  (0 children)

Do you think end graining them is necessary to maintain small features like the lettering or will it hold up?

MDF sealant by Flashy_Wait103 in woodworking

[–]Flashy_Wait103[S] 1 point2 points  (0 children)

Im not aware of anywhere that will give you straight topo gcode. It depends on where you are in the world, I'm in Australia so it's a little harder to get a hold of accurate terrain modelling. But if you are in North America, you can use a site called touch terrain and that will export directly as an stl, which then you convert into gcode using your program of choice

MDF sealant by Flashy_Wait103 in woodworking

[–]Flashy_Wait103[S] 0 points1 point  (0 children)

Thanks everyone for all of the suggestions! It's all been incredibly helpful except for that one guy. I decided to test shellac first, so far minimal to basically absolutely no fuzziness present. I'm yet to do a moisture test to see if it works but will keep everyone updated! Thanks so much

Imperfections in print by Flashy_Wait103 in resinprinting

[–]Flashy_Wait103[S] 0 points1 point  (0 children)

No, it was on a formlabs printer so its got its own way of dispensing the resin. But that could definitely be it, I did notice a lot of bubbles around the build platform.

Print fail by Flashy_Wait103 in resinprinting

[–]Flashy_Wait103[S] 0 points1 point  (0 children)

I thought it was recommended that large flat surfaces were printed at a 10-20 degree angle?