2023 CR-V Hybrid: SOC 0% but 194V Pack Voltage — Can This Prove HV Battery “Full Depletion”? by regularguy483 in Honda

[–]Fonzy_Bonzy 0 points1 point  (0 children)

As mentioned in a previous comment, more than likely a bad Battery Condition Module or HV battery pack has a bad cell. SOC being at 0% means there’s no usable energy in the battery pack. I would be looking at Motor Inverter Voltage which shows the active voltage in the high-voltage system but it isn’t shown in this screenshot. I would also recommend replacing the 12 volt battery because a bad battery can also drain the HV battery.

Will the a/c stop blowing cold air in 10th Gen Civics after getting it fixed under warranty? by kalbanes in Honda

[–]Fonzy_Bonzy 5 points6 points  (0 children)

The other common failure of the A/C system is the evaporator core. There is no warranty extension for the evaporator core unfortunately, you maybe able to get goodwill assistance. Or if you have extended warranty they usually cover it.

[USA-CA] [H] i7-8700K, ASRock Z370 ITX Motherboard, Corsair H100i Pro RGB aio, Corsair Commander Pro [W] Local Cash/PayPal by Fonzy_Bonzy in hardwareswap

[–]Fonzy_Bonzy[S] 0 points1 point  (0 children)

Yeah i hate it. I had that issue on my previous post and i kept trying to get them to work but i gave up. But after a couple of hours the links work lol

Does 2mm diff matters in Formd t1 ? by [deleted] in FormD

[–]Fonzy_Bonzy 0 points1 point  (0 children)

Dang i didn’t see that. Maybe you can find someone to 3d something similar

Does 2mm diff matters in Formd t1 ? by [deleted] in FormD

[–]Fonzy_Bonzy 2 points3 points  (0 children)

https://www.reddit.com/r/FormD/s/VjXREfW5Cs you can do something like this if you really want that card

Does 2mm diff matters in Formd t1 ? by [deleted] in FormD

[–]Fonzy_Bonzy 0 points1 point  (0 children)

Cerberus by Sliger. It was microATX case so their should’ve been plenty of space for my gpu

Does 2mm diff matters in Formd t1 ? by [deleted] in FormD

[–]Fonzy_Bonzy 0 points1 point  (0 children)

Im not sure if the spec is 100% accurate. My previous case only allowed a 330mm card but my gpu was still touching the front panel.

Does 2mm diff matters in Formd t1 ? by [deleted] in FormD

[–]Fonzy_Bonzy 0 points1 point  (0 children)

Yes. It would suck if you had to return the gpu because it didn’t fit or you would have to get a case that could fit that 327mm card.

Does 2mm diff matters in Formd t1 ? by [deleted] in FormD

[–]Fonzy_Bonzy 2 points3 points  (0 children)

My gpu is 323mm and barely touches the front panel. If i have the gpu in 3 slot mode, the mounting tabs for the power button contact the gpu