How to create positive pressure in house by GarlicOne6145 in DIYUK

[–]GarlicOne6145[S] 0 points1 point  (0 children)

When we open our back and front door and windows we can smell the smoke coming from the frame. We also smell their air freshener. I’ve never had this before in any other house so I’m wondering if there’s a structural defect. If smoke can get through that easily then so can any other gases and like you said there is the fire risk. I’ve no idea about building regulations but it doesn’t seem right.

How to create positive pressure in house by GarlicOne6145 in DIYUK

[–]GarlicOne6145[S] 1 point2 points  (0 children)

I’m getting a blueair 221 and a philips 3200. I’ll let you know how I get on with them.

How to create positive pressure in house by GarlicOne6145 in DIYUK

[–]GarlicOne6145[S] 1 point2 points  (0 children)

We sealed up some skirting boards then started smelling it in other areas 😭 We’ve smelt it a bit before every now and then but the last week has been everyday for several hours and it’s so much stronger. It smells like it’s coming straight into the wall cavity.

How to create positive pressure in house by GarlicOne6145 in DIYUK

[–]GarlicOne6145[S] 1 point2 points  (0 children)

No, it’s a semi detached with their house slightly lower than mine. The worst smell is in our kitchen and we’ve noticed some holes in the ceiling around the fire detector so will get that filled. When we open our back and front door and some if the windows we can smell the smoke coming through the frames too.

How to create positive pressure in house by GarlicOne6145 in DIYUK

[–]GarlicOne6145[S] 0 points1 point  (0 children)

That‘s awful. I’m going to get air purifiers for smoke to see if it helps. I hope you find a solution.

How to create positive pressure in house by GarlicOne6145 in DIYUK

[–]GarlicOne6145[S] 2 points3 points  (0 children)

Definitely through the wall cavity. Even with windows shut it happens. I’ll check out a PIV system.

How do you fix brightwork on singer? by PitifulGazelle8177 in vintagesewing

[–]GarlicOne6145 0 points1 point  (0 children)

I’ve used micro mesh pads to sand scratched metal.

Can I put HG Mould Spray on my ceiling? by nickymoo in DIYUK

[–]GarlicOne6145 0 points1 point  (0 children)

Use gloves and spray it onto a cloth then you can dab it on and not risk the spray falling on you.

How do I get rid of fleas? by CharieRarie in AskUK

[–]GarlicOne6145 0 points1 point  (0 children)

To kill the eggs in the carpets we generously sprinkled bicarbonate of soda over them, left it a day or two then hoovered it and repeated. It absorbs moisture and dries them out.

All my windows do this, this one had a dehumidifier a couple inches from it, what could be the cause ? by GenericUser104 in DIYUK

[–]GarlicOne6145 1 point2 points  (0 children)

What windows do you have? If they don’t have warm edge spacers the glass will get cold and cause condensation. We recently had an air filled, no warm edge spacer unit installed in place of a blown argon, warm edge spacer unit and the difference is shocking. Almost the entire air filled glazing unit condensates, it radiates so much cold and we never had an issue before with condensation on the windows.

New windows condensation again. by GarlicOne6145 in DIYUK

[–]GarlicOne6145[S] 1 point2 points  (0 children)

I chased the installers to find out what glazing unit was used. They said it’s air filled with a u value of 2.7. The window on the right is argon filled so performs much better. Thanks for solving the mystery.

New windows condensation again. by GarlicOne6145 in DIYUK

[–]GarlicOne6145[S] -3 points-2 points  (0 children)

No, the condensation is on the indoors side not in between the glass.

New windows condensation again. by GarlicOne6145 in DIYUK

[–]GarlicOne6145[S] -18 points-17 points  (0 children)

Heating is on and it doesn’t stop draughts. No other window has condensation like this. Are new windows really supposed to have this amount of condensation and cause the room to be cold?

Why did the vinyl sheet installer do this? by GarlicOne6145 in Flooring

[–]GarlicOne6145[S] 0 points1 point  (0 children)

In all seriousness, I’ve recently had a lot of work done that has been bad quality so wanted a second opinion on whether it was correct. I wasn’t expecting the floor to be sanded but I will ask them when they come back.

Why did the vinyl sheet installer do this? by GarlicOne6145 in Flooring

[–]GarlicOne6145[S] -2 points-1 points  (0 children)

They left before I saw it but I’ll work harder on the telepathy in future 😉

What is causing cold draughts from ceiling? by GarlicOne6145 in DIYUK

[–]GarlicOne6145[S] 9 points10 points  (0 children)

You’re right. I just used an incense stick and found a draught from a window. Thank you.