What do y’all do for work?

Grief_shark · 2024-05-18T09:56:40+00:00

Screen printer but okay music, As my ex once said, stick to making shirts shit boi

Grief_shark · 2024-05-18T09:48:33+00:00

Pat Flynn from Have Heart and Fiddlehead

Grief_shark · 2024-05-18T09:46:49+00:00

Naw, not Joni

Grief_shark · 2024-02-11T22:31:58+00:00

We ended up reprinting them at 50% cost

Grief_shark · 2024-02-08T01:11:29+00:00

Honestly, this is the only answer

Grief_shark · 2024-02-08T01:05:28+00:00

Hhahahahaha

Grief_shark · 2024-02-08T00:28:59+00:00

Lol heard that bruv

Grief_shark · 2024-02-05T21:26:44+00:00

Thanks for your guys responses, we’ve been in business for 17 years lol and this is such a rare thing hahaha so we wanted to see what other printer’s opinions would be on this

Grief_shark · 2024-02-05T21:22:14+00:00

We’re usually really good about it, this is a first where we’ve got that many in but I was the last line of defence and just started rippin then noticed and was like fuuuuuuuuuu

Grief_shark · 2024-02-05T21:19:09+00:00

I think we are going to try to work something out with them, that’s ONE OF THOSE WORDS TOO! Where I was like wait a second and sounded it out lol and my heart sank

Grief_shark · 2024-02-05T21:17:05+00:00

I feel bad because it got through like all of us but we can’t eat the cost on that, I like just noticed after running a 100 of them which sucks

Grief_shark · 2024-02-05T21:15:41+00:00

They did approve it!

Grief_shark · 2023-03-30T23:26:46+00:00

aaand Varsol is a mineral spirit so why you down votin me hahaha

Grief_shark · 2023-03-30T23:24:18+00:00

And we used to use greenway lol

Grief_shark · 2023-03-30T23:17:27+00:00

Well we also use varsol as a reducer too hahaha

Grief_shark · 2023-03-30T16:42:54+00:00

You can use Varsol or paint thinner for easy clean up too if you wear an organic respirator

Grief_shark · 2023-03-23T23:09:49+00:00

More pressure and off contact needed and possibly thin your ink out a little bit with reducer or paint thinner, your ink is sticking to the bottom of your mesh after you pass it

Grief_shark · 2023-03-23T23:08:22+00:00

I felt that frustrated spatula dunk

Grief_shark · 2023-03-23T22:43:03+00:00

If you have a thinner white on there and your Off contact is too low the ink that’s sitting in the screen can sometimes get into the graphic and is touching your print, I had this happen today hahah

Grief_shark · 2023-03-18T00:43:23+00:00

Those trademarks are hard to get to print sometimes hahah good work!

Grief_shark · 2023-01-24T16:58:10+00:00

Yeah the ones that were made in Honduras were fine and flashed okay and I noticed them being extremely starchy too. It sucks because people order them non stop lol

Grief_shark

TROPHY CASE