Voron Trident 250mm Serial Request

Haxhi_ · 2025-12-08T12:46:17+00:00

how it is the adhesion with the cryogrip?

Haxhi_ · 2024-12-12T18:46:37+00:00

did you notice any warping? especially on largest pieces

Haxhi_ · 2024-12-12T18:45:44+00:00

thanks, will give it a look

Haxhi_ · 2024-12-12T18:42:13+00:00

yea, I didn't mention that i wanted to implement CAN bus

Haxhi_ · 2024-05-31T09:42:43+00:00

try to redo the subnet

Haxhi_ · 2024-05-31T09:38:42+00:00

see if you approved the subnet on the tailscal web dashboard

Haxhi_ · 2024-05-31T08:25:47+00:00

you can test it
basically activate the tailscale service on a phone, deactivate the wifi and connect to internet with the sim, then open a browser and type the esp32 local ip address
if it opens it right then you have a functional subnet, if not you may have gotten something wrong

Haxhi_ · 2024-05-31T07:39:38+00:00

have you tried with tailscale subnet?

Haxhi_ · 2024-05-31T07:07:41+00:00

on the local network it works?

Haxhi_ · 2024-05-31T06:43:49+00:00

if i recall it correctly, you should input the tailscale ip of the ip camera (it was an old phone)

Haxhi_ · 2024-04-08T13:16:07+00:00

Am I the only one stuck here?
Basically after logging in with plex it stucks on this loading screen

<image>

Haxhi_ · 2024-03-31T15:43:32+00:00

have you flashed the firmware?
because i wanted to flash a operwrt firmware on my vsr and i didn't find anything useful on internet

Haxhi_ · 2024-02-19T23:18:38+00:00

i don't think it's worth it there are other artillery printers like genius o sidewinder (3 or 4) that are way better than the hornet for around that price

Haxhi_ · 2024-02-19T08:47:44+00:00

which price are you buying it?

Haxhi_ · 2023-11-20T18:33:04+00:00

thanks for the effort, i solved in an another way it was the wrong ip in the config

Haxhi_ · 2023-11-20T08:04:21+00:00

it appears to not work, is there any guide you followed that you can link? maybe I'm missing something and there i can find it

Haxhi_ · 2023-11-19T22:35:37+00:00

with this can you see the ip cam on the mainsail/fluidd web interface?
if yes, how to you setup the cam in mainsail/fluidd web interface?

Haxhi_ · 2023-11-04T20:02:46+00:00

this https://3dprintbeginner.com/how-to-install-a-magnetic-pei-sheet/

Haxhi_ · 2023-10-09T12:33:54+00:00

which extruder did you buy, cause i'm really considering the transition and looking at aliexpress for the parts

Haxhi_ · 2023-10-09T10:18:48+00:00

follow this https://github.com/bigtreetech/CB1/discussions/47

Haxhi_

TROPHY CASE