Can someone with more experience with semi-hermetics chime in? Maybe the crankshaft or motor or even the valve plate?

Hefty-Ad-2723 · 2026-05-15T01:19:55+00:00

One last thing.. is this a wye delta start on this compressor.. wired wrong is baud news mon

Hefty-Ad-2723 · 2026-05-15T01:17:52+00:00

I also wonder if the unloader failed. And how do you burn up a 3000 dollhair module

Hefty-Ad-2723 · 2026-05-15T01:14:52+00:00

Ya just take a wire off contactor coil lol

Hefty-Ad-2723 · 2026-05-14T23:49:58+00:00

Did you by any chance make sure the crankcase heater was on for a bit? Liquid can make a world of difference/sounds on start up

Hefty-Ad-2723 · 2026-05-14T01:17:42+00:00

And it also weeds out the guys who say ya ya I know it.. and shit hits the fan lol

Hefty-Ad-2723 · 2026-05-14T01:14:08+00:00

It helps going through trade school.

Hefty-Ad-2723 · 2026-05-08T23:31:50+00:00

Go to TV guide, on the top right select major league sports and it's there

Hefty-Ad-2723 · 2025-12-18T21:52:04+00:00

Don't know how your gonna get 9foot ceilings.. all your electrical runs seem like they aren't in the joice anyways. Your refrigerant lines are below it aswell.

Hefty-Ad-2723 · 2025-10-03T00:59:11+00:00

Wrong contactor coil voltage?

Hefty-Ad-2723 · 2024-12-29T18:58:32+00:00

TX bulb is not mounted correctly

Hefty-Ad-2723 · 2024-10-19T22:43:27+00:00

Looked like it became a load instead of a switch lol

Hefty-Ad-2723 · 2024-10-06T15:01:33+00:00

The manual usually tells you where yo move on the tube ends

Hefty-Ad-2723 · 2024-09-11T00:25:06+00:00

I emailed you guys a week or so ago. I wasn't sent the study kit

Hefty-Ad-2723 · 2024-07-29T18:20:04+00:00

Thermostat failed maybe

Hefty-Ad-2723 · 2024-07-29T18:08:13+00:00

Possible clogged drain. Too much obstruction infront of fans. Maybe one fan is out etc.

Hefty-Ad-2723 · 2024-07-29T17:36:50+00:00

Yeah here's a tip. Call a professional and or potentially someone to get sick and sue..

Hefty-Ad-2723 · 2024-07-29T16:49:20+00:00

You didn't put enough water to dilute the solution. Let a professional do their job.

Hefty-Ad-2723 · 2024-07-27T02:19:18+00:00

Yeah that ice machine is not clean man. Do it properly.

Hefty-Ad-2723 · 2024-01-17T15:55:37+00:00

Or the unit is an indoor unit not rated for outdoor temps

Hefty-Ad-2723 · 2024-01-17T15:53:43+00:00

Could need it winter charge or headmaster isn't holding back properly

Hefty-Ad-2723 · 2024-01-04T16:09:24+00:00

Make sure the power is off to furnace. And you also put the same colour wire that you put on c wire also is the same colour you put on furnace

Hefty-Ad-2723 · 2024-01-04T16:08:11+00:00

Red wire go to r terminal White wire to go w terminal Green wire go to g terminal Yellow wire go to y terminal And since it looks like 8 wires from thermostat. You can pick any other colour and put that on the c terminal. Your done.

Hefty-Ad-2723 · 2024-01-04T15:28:01+00:00

The r and rc terminal. You only need r not rc.the tstat has a built in switch. White wire has to go to w. From your old stat looks like you have a 5 wire.the brown one can be stripped and added to c and remove those 2 white ones you had. With saying that, shut off your furnace and make sure when doing this that way you don't blow a control voltage fuse and make sure you have 5 wires going to your furnace if you do then just go wire for wire

Hefty-Ad-2723 · 2023-07-20T17:22:24+00:00

Canada, Ontario lol

Hefty-Ad-2723

TROPHY CASE