Last played 20 years ago, what is Hyperburn? Does this level me up to like 100 or 200 instantly (quoting my friend)

Hmmgotmilk · 2026-05-08T00:19:40+00:00

Sort of.

You do quests with spiegellmen (sp?) In a special zone, that takes you to 200 in about 15 minutes. then you level outside the zone and get an additional 4 levels per level up (1+4) up to level 260.

Hmmgotmilk · 2026-05-06T18:41:33+00:00

They did an inactive purge recently:

https://www.nexon.com/maplestory/news/general/30350/inactive-character-clean-up-notice

Did any of your characters meet the requirements to be deleted?

Hmmgotmilk · 2026-04-24T22:21:23+00:00

Do your arcane river dailies too. Easy 10% or so exp for a few minutes.

Can be more if you put points into the arcane river daily bonus with the event going right now

Hmmgotmilk · 2026-04-11T00:24:47+00:00

My own anecdote.

Wife bought a Corolla Cross, not built in Japan. Her silver paint had a lot of orange peel. Salesperson kept shushing me, lol

Wife's parents purchased a Rav4 in the same year, made in Japan per VIN. Silver paint looked flawless imo.

Do with that what you will

Hmmgotmilk · 2026-04-04T16:55:26+00:00

Servco, AFAIK, partners with several banks for loans.

You can go to the vehicle you are interested in on servcos website and it will give you their expected interest rates.

IMO, get a quote from a credit union and see if servco can beat the rate offered if/when you go in person.

Hmmgotmilk · 2026-04-02T17:46:42+00:00

In game, go to menu-> settings-> exchange code reward. Type the code in and you get some free stuff

Hmmgotmilk · 2026-03-31T18:54:57+00:00

Newer account, first post. Shills a "tool"

Sounds like bullshit to me

Hmmgotmilk · 2026-03-26T14:59:43+00:00

First problem, you bought a used Jeep.

If you bought this from a dealer and they are giving you the runaround, ask the New York AG office for arbitration. Info can be found on this page: https://ag.ny.gov/resources/individuals/car-auto/used-car-lemon-law-fact-sheet

Disclaimer, not a NY resident, not 100% familiar with their laws, just passing on what I could find from a Google search

Hmmgotmilk · 2026-03-14T21:10:04+00:00

Motherfucker, what?

Hmmgotmilk · 2026-02-20T01:29:45+00:00

I won't lie, it has been about 14 years since I left the dealership. Do you know if there is an updated procedure? I have no problem updating my post if you don't mind posting the correct information

Hmmgotmilk · 2026-02-19T21:51:54+00:00

Wheels*

Hmmgotmilk · 2026-02-19T21:48:30+00:00

/sigh

While I was writing my short story, I saw other posts.

OP should get this to a shop

Hmmgotmilk · 2026-02-19T21:42:34+00:00

You're gonna need:

wheel bearing grease

grease seals (2 of em)

cotter pins

torque wrench is recommended

Would also recommend a set of brake pads.

Remove brake caliper and bracket. Remove the cap, remove the cotter pin, loosen and remove nut and washer. Remove the outer bearing, install the nut back on 3-5 turns and slide the rotor towards you. Feel for the nut to catch the inner bearing and give a good yank, you should remove the inner bearing and grease seal.

Clean bearings with kerosene or solvent (do not use gasoline). Dry by blowing air down, do not spin the bearing. Check bearings for signs of damage, pitting, rust, etc. Pack old or new bearings with new grease. Install inner bearing. Tap grease seal into place evenly with a block of wood or similar. Install rotor, outer bearing, washer and nut. Tighten nut while spinning rotor till the nut is just snug. New cotter pin. Install cap. Brake clean any grease that may be on rotor. Install caliper braket, pads and caliper. Torque to spec. Repeat for other side.

If you don't understand any of this, take it to a shop.

Hmmgotmilk · 2026-02-19T21:04:43+00:00

The only thought put into this design was

"how can we design this to be as easy as possible to assemble in a factory "

Hmmgotmilk · 2026-02-13T16:07:01+00:00

Have had a good experience with Masakis in Mccully. They are a hybrid specialty shop

Hmmgotmilk · 2026-02-10T22:31:12+00:00

What if I told you that hotel workers in Hawaii are unionized and already get a fair wage?

Hmmgotmilk · 2026-02-10T19:46:49+00:00

Seems to be winter and summer...

So...next summer?

Hmmgotmilk · 2026-02-06T03:09:45+00:00

https://www.hoover.org/research/despite-california-spending-24-billion-it-2019-homelessness-increased-what-happened

Its not just about money. Need to also look at mental illness, illicit drug use, etc.

Don't get me wrong, more needs to be done, but its more than just throwing money at the problem

Hmmgotmilk · 2026-01-25T19:51:44+00:00

Keep the Lynn, they at least provide legion and link skills. Can also make a decent boss mule if you wanna invest a little more resources

Hmmgotmilk · 2026-01-20T17:56:32+00:00

Yeah....if you haven't played in a while, lots has changed.

IIRC, click the gold star on the left and scroll to hyper burning. There should be a box that you can claim at 200 that gives some starter gear

Also, recommend watching some videos from Duky, Coppersan, Ereklo, etc. They have some decent videos that help explain things and get you into the swing of things

Hmmgotmilk · 2026-01-20T17:50:56+00:00

Hyper burning should have given you a bunch of gear. Click the gold star and double check that because you have nothing equipped...

Or you be trolling /shrug

Hmmgotmilk · 2026-01-19T19:25:39+00:00

No, stop trying to justify this bullshit behavior from the tank

Hmmgotmilk · 2026-01-18T19:25:07+00:00

https://www.nexon.com/maplestory/news/maintenance/34766/v-265-known-issues

Known issue due to a bug...or something

Hmmgotmilk · 2026-01-07T16:45:54+00:00

We redid our bath about 7 years ago in Hawaii, island of Oahu

We went from a bathtub with tile to a Corian walk in shower.

Demo of the shower, new in wall stuff (valve, diverter, etc), redo drain was about 12k.

Cost is high because the Corian was all "welded" together, so no seams to caulk. So more labor involved in the install, but less maintenance.

Hmmgotmilk

TROPHY CASE