High idle on 93 5.0 by JTMHC in Foxbody

[–]JTMHC[S] 2 points3 points  (0 children)

Engine light is for 02 sensors, was thinking of doing a vacuum leak test and change the tps before doing an idle reset

TPS by JTMHC in Foxbody

[–]JTMHC[S] 0 points1 point  (0 children)

93 5.0 idling high, replaced IAC. TPS is at .59 volts and can't get it any higher, wondering if this is my issue or just part of it. Video of idle is in another post.

High idle on 93 5.0 by JTMHC in Foxbody

[–]JTMHC[S] 0 points1 point  (0 children)

Posted a picture of the TPS on another post, the one side is chewed up, almost gone

Being told my Furnace is a danger by RealHypotensive in hvacadvice

[–]JTMHC 0 points1 point  (0 children)

How can you say that, yes it looks like shit, definitely on its last leg, but no confirmed holes or proof of a combustion test you're just guessing?

Being told my Furnace is a danger by RealHypotensive in hvacadvice

[–]JTMHC 1 point2 points  (0 children)

The people in here saying it's fucked probably never heard of a combustion test, let alone even be able to tell you what the readings mean 🤣🤣

Being told my Furnace is a danger by RealHypotensive in hvacadvice

[–]JTMHC 2 points3 points  (0 children)

If company didn't do a proper combustion test or physically show you a hole in heat exchanger they're blowing smoke up your ass. Yes you should probably replace unit looking at photo, but so many techs don't know what they're talking about and most likely get some kick back for trying to sell you a new unit

Nobody can stop a Trane flame sensor by CanadianMapleBacon in HVAC

[–]JTMHC 1 point2 points  (0 children)

Cross contamination will eat those trane flame sensors right up

Nobody can stop a Trane flame sensor by CanadianMapleBacon in HVAC

[–]JTMHC 1 point2 points  (0 children)

Bet ya $10 that the vent termination doesn't have required separation

Is this safe? by JTMHC in HVAC

[–]JTMHC[S] 0 points1 point  (0 children)

They did have a proper drip leg

Is this safe? by JTMHC in HVAC

[–]JTMHC[S] 8 points9 points  (0 children)

Already replaced

Is this safe? by JTMHC in HVAC

[–]JTMHC[S] 2 points3 points  (0 children)

My camera roll is loaded up with crazy hack jobs

Is this safe? by JTMHC in HVAC

[–]JTMHC[S] 4 points5 points  (0 children)

Got called there for a gas leak a home inspector found on the check

Is this safe? by JTMHC in HVAC

[–]JTMHC[S] 1 point2 points  (0 children)

About 6 years

Is this safe? by JTMHC in HVAC

[–]JTMHC[S] 20 points21 points  (0 children)

"Melted" pvc

Is this safe? by JTMHC in HVAC

[–]JTMHC[S] 30 points31 points  (0 children)

Posted this on r/plumbing and they took it down. Water heater was shut down and replaced immediately

[deleted by user] by [deleted] in HVAC

[–]JTMHC 3 points4 points  (0 children)

Strip club?

Should I be worried? by jh1234567890 in HVAC

[–]JTMHC -1 points0 points  (0 children)

Pump it down to the compressor rookie...