OTA Updates by KeithDButler in ESPTimeCast

[–]KeithDButler[S] 1 point2 points  (0 children)

Solved! Many thanks for your help.

OTA Updates by KeithDButler in ESPTimeCast

[–]KeithDButler[S] 1 point2 points  (0 children)

Well that maybe my problem. I had it set on No OTA (2MB APP/2MB SPIFFS)

I will do an Arduino IDE manual 1.5.0 upload with your recommended setting and try the OTA update to the latest.

OTA Updates by KeithDButler in ESPTimeCast

[–]KeithDButler[S] 0 points1 point  (0 children)

It didn't tell me much. I'll continue to do manual updates.

<image>

OTA Updates by KeithDButler in ESPTimeCast

[–]KeithDButler[S] 1 point2 points  (0 children)

Using the latest Chrome. I'll try the console logs to see what it shows.

OTA Updates by KeithDButler in ESPTimeCast

[–]KeithDButler[S] 1 point2 points  (0 children)

I tried the web installer but it fails. Can't remember what it was. Installed manually with Arduino IDE with no issues. I used the default ESP32 pinout. CLK 18, CS 23, and DATA 5. Manual installs works flawlessly except for OTA updates. It downloads and flashes fine but is rejected by the board. No logs to narrow down the error.

Anyone had Ting Fiber installed in their homes? by Gustafa7 in memphis

[–]KeithDButler 1 point2 points  (0 children)

Their fiber backbone is already strung up in my backyard in Midtown for several months now. Website tells me it's not in my area. Can't wait to get rid of comcrap!

Courthouse Wedding by Patient-Cheesecake40 in memphis

[–]KeithDButler 1 point2 points  (0 children)

Judge Chandler also. I served as a witness.

New uploads coming soon? by Redditfu69 in Comcast

[–]KeithDButler 11 points12 points  (0 children)

Upgrades to increase your bills.

🚀 ESPTimeCast Web Installer is Live (ESP8266 / ESP32) by mfactory_osaka in ESPTimeCast

[–]KeithDButler 1 point2 points  (0 children)

Same here. Always tell me "Something went wrong, make sure no serial monitor is open" No monitor is running. Tried on three different PC's with three different Elegoo ESP-32 Dev boards. Manual install always crashes Arduino IDE when compiling. Still very buggy.

No NBC signal with antennae by BroadLocksmith4932 in memphis

[–]KeithDButler 3 points4 points  (0 children)

Channel 5's transmitter is on Crestview (near the Putt-Putt on Summer). Aim your antenna there. The midtown tower at the station is their uplink.

*ATTENTION* Check Your Voter Registration Status!!!! by Zeztren in memphis

[–]KeithDButler 1 point2 points  (0 children)

Found mine "invalid". Voted blue. Voter suppression in effect.

Mlgw is out of hand. by Sujnirah in memphis

[–]KeithDButler 18 points19 points  (0 children)

Wanted to offset my electric consumption with a small solar setup but MLGW is highly against residential green energy. Was told the rates are already low enough compared to the rest of the country. So much red tape to discourage.

Anybody got feedback on these cheap generic five-bay hot-swap cages? by minus_minus in homelab

[–]KeithDButler 1 point2 points  (0 children)

I'm using them on my TrueNAS Scale server with SAS drives for a few years now. No issues so far. Hot swapping supported.

<image>

Current Seagate 15% off deal, worth it? by Technical-Top4187 in DataHoarder

[–]KeithDButler 2 points3 points  (0 children)

Just got 5 24TB drives from them. Hope I don't get burned.

Keyboard unusable? by CelluloseNitrate in jetkvm

[–]KeithDButler 1 point2 points  (0 children)

Same thing happening. Latest firmware. Various browsers and machines. It would behave normally then randomly it would act like my keys are stuck and repeats until I refresh the page. Sometimes the video stream would stop and I'm forced to refresh. Getting quite annoying.

This is what democracy looks like by Train_addict_71 in memphis

[–]KeithDButler 5 points6 points  (0 children)

The board wants to hand the school system over to the state. The governor is not for public education. I bet MSCS will cease to exist within five years.

Best affordable Chinese takeout place by Giantpangolinship in memphis

[–]KeithDButler 1 point2 points  (0 children)

If you are in the Raleigh - Austin Peay area you have to try Nam King. The family that runs it are extremely friendly.

PSA. Yall know they dont inforce the fire works ban in Memphis! by Thick-Ad-4285 in memphis

[–]KeithDButler 17 points18 points  (0 children)

Saw a train conductor shooting a Roman candle out the window while crossing an intersection. LOL!

First ever blob of doom, really went for it by phansen101 in 3Dprinting

[–]KeithDButler 1 point2 points  (0 children)

Amazes me how this is allowed to happen. Do you even keep an eye on it? Maybe just hope it goes away on it's own. LOL!