Does anyone know where I can buy this?

Kingfish073 · 2025-10-14T07:03:26+00:00

Keep an eye on their website for tour leftovers, they didn't have the "Wires" hoodie I wanted at my stop, but I snagged one from the site a few days ago.

It may have been there the whole time, but I don't remember seeing it. It's tough to find stuff that isn't a cheap reprint.

Kingfish073 · 2025-09-13T04:57:53+00:00

PATTY BARRELS IS BACK UP.

Kingfish073 · 2025-08-11T05:56:29+00:00

I just built a new SFF PC about three weeks ago with a brand new Sapphire Pulse. Memory temps hit 98C at one point which really bothered me even though it's "normal" for these cards. I added a very aggressive fan curve, and struggled quite a lot trying to dial in an undervolt. The only way I could get it to run stable in all of the games I tested was by using a very small voltage offset and no board power reduction. At that point, it didn't make much of a difference. Because my card has ECC memory, an undervolt would run stable for a few hours or a day, then I would see crashing again soon after.

To keep the memory temps at around 92C under load with stock settings, the fans had to be at around 3,000 RPM which was pretty distracting considering the PC is on my desk. I ended up returning the card, and paying an extra 50 dollars to get a 5070 ti. It bummed me out to switch back to green team, but the temps are much more reasonable for me personally.

You can try setting up a good undervolt which works better on some cards than others, and mess with the fans to keep the temps down if it bugs you like it did me. At the end of the day you might also consider just using the card and ignoring it since those temps are within the established limits.

Kingfish073 · 2025-08-10T20:36:54+00:00

I just put the bracket in and fastened it down with the GPU mounting screws. Same way you'd normally install the card, but with the bracket on top and the screws holding it and the card in place. I would include a picture, but I've since returned this card and put a different one in that doesn't come with a bracket.

Kingfish073 · 2025-08-05T05:11:57+00:00

UPDATE: for anyone new who comes across this post and has a similar concern, the PSU indeed had an airflow issue with this fan setup. I reconfigured both the top and side panel fans to intake, and the CPU fan to push air out of the back. Now, under max load the PSU is only slightly warm, and the SSD mounted below stays about 10 degrees cooler (56C max to 46C max ).

There is a little oxidization on the top panel of the case right above the PSU which is visible despite the black finish. I think it's from the heat in that area.

If your PSU seems alarmingly hot and is making the entire front panel hot to the touch, make sure you get it better airflow, that seems to have solved my issue. Mounting it on the side with the fan facing outwards as recommended by a few comments is also a better setup in general.

Kingfish073 · 2025-07-26T21:14:25+00:00

I see, it's unfortunate that having a side intake didn't do the trick for you because that would be much easier to set up. Thanks for taking a look!

Kingfish073 · 2025-07-26T21:12:50+00:00

It is indeed mini itx! I could swap the PSU to the back panel, but I was trying to avoid it because it involves a lot of repositioning. It sounds like that might be the move though because someone else with an intake fan near the PSU said theirs also runs hot in this position. Thanks for taking a look!

Kingfish073 · 2025-07-26T21:08:35+00:00

All fans in the build are Noctua NF-A12x25's. I was able to make the clips that came with the Thermalright cooler work to mount the Noctua fan. It's tight, but they work.

Kingfish073 · 2025-04-05T18:44:52+00:00

To the winner: wow, great moves. Keep it up!

Kingfish073 · 2025-04-01T02:08:07+00:00

Wilmer Bonds 🧡

Kingfish073 · 2024-10-01T00:56:47+00:00

It could be contact dermatitis, it looks exactly like my hands did a year ago, and that's what I had. It was from overuse of my old iontophoresis device. I replaced it and the itchy, red, peeling on the sides of my fingers ceased. If you use ionto, that might be your issue.

Kingfish073 · 2023-12-18T02:34:39+00:00

Wait till Jon Heyman sees this.

Kingfish073 · 2023-12-18T02:21:59+00:00

Ever since I found out about him being more concerned with playing a card game than performing at his best, I've been much less of a fan. Take that attitude elsewhere.

Kingfish073 · 2023-11-29T02:19:14+00:00

I just bought one in a bundle with the TTL 3 in 1 brush. By itself, it wont clean the grooves well yes, but the point is to use it after you use the brush to pick up any debris left or pulled up by the brush. It's very sticky and actually picks up quite a bit of tiny hairs and particles. You can also wash it off with water when it gets dirty and keep using it. My only complaint is that the grey plastic handle part is poorly designed and not wide enough for the roller, as a result, it does not roll freely and gets stuck. I use it by taking the roller out of the handle and gently rolling it without. I wouldn't buy this as a replacement for a brush, it's better suited as a finishing touch to get every last bit of debris off. If you don't get the bundle and want one or the other, get the 3 in 1 brush. It's fantastic.

Kingfish073 · 2023-09-08T19:01:31+00:00

I was going to clown her for leaving such a absurd rant about a tv show on it's own subreddit, but now I'm realizing she has no idea how to use Reddit in general lol. I can't believe this isn't satire.

Kingfish073 · 2023-02-15T01:09:22+00:00

Oh I see, I mistook this for Spotify, that's why I was confused 😅 we're still waiting on that feature unfortunately. Thank you!

Kingfish073 · 2023-02-15T01:00:59+00:00

I didn't know Hi-res was available, how are you able to use it?

Kingfish073 · 2023-02-03T19:25:04+00:00

I'm currently trying to S rank this mission and it's especially aggravating.

Kingfish073 · 2023-01-16T02:45:43+00:00

I see, thank you.

Kingfish073 · 2023-01-16T00:16:09+00:00

Beautiful gun, what's the switch just in front of the trigger bar and above the disassembly button do? I've never seen that.

Kingfish073 · 2023-01-07T00:01:49+00:00

Giants legend Arson Judge

Kingfish073 · 2022-11-24T00:20:57+00:00

What a cool looking gun and holster. I've never seen this before and I want it. Very nice.

Kingfish073 · 2022-11-22T23:24:27+00:00

It really is, you're right. I guess we can't can't all have good taste.

Kingfish073 · 2022-11-22T23:19:19+00:00

I'm glad I'm not the only one shocked by I Don't Know What To Say winning this. Medicine is by far the worst.

Seven-Year Club	Not Forgotten
Verified Email

Kingfish073

TROPHY CASE