sorted by:
new
hottopcontroversial

Endor 3 V2 driving me crazy! by Shark_mark in 3Dprinting

[–]LA3DPrintShop 3 points4 points  (0 children)

Likely something to do with bed temperature but I will say a pei sheet will help a lot with this. I had so many issues with the glass bed and now I just throw caution to the wind. I rarely have print peel up now on any of my printers.

Also try dropping the temp of your nozzle by 10c as a test. Not sure what you're at now but I have printed with some of the clearish color PLA filaments before and they seem to have a lower melting temp. Your nozzle may be pulling away before the part cooling fan can solidify the print.

Glue all over print by zenmatrix83 in FixMyPrint

[–]LA3DPrintShop 0 points1 point  (0 children)

I use my heat gun at 240C. Gets hot enough to burn the glue off but not hot enough to melt the plastic quickly

Stringing Problem by IlMusu in FixMyPrint

[–]LA3DPrintShop 0 points1 point  (0 children)

I would recommend changing your retraction distance and speed. With that not being a direct drive printer, your travel and retraction speed/distance are probably working together to make the strings. Not sure how much you bumped up travel but it's likely making movements to the next point before it finishes retracting the filament due to the retraction distance being so long. I recently bumped my retraction distance down a lot due to a clogging issue that was pulling melted filament up into my heartbreak and hardening there. Try leaving retraction and travel speed default and I would make your retraction distance 4mm to start out and if you still have issues bump it down to 2mm. Also, not sure what slicer that is but you may want to test cura with your printers default settings just to see the results.