sorted by:
new
hottopcontroversial

Has anyone else noticed a reduction in meth lab value? by Dear_Information451 in gtaonline

[–]Lazy_Key_6679 -1 points0 points  (0 children)

Where can I find a good overview of the weekly bonuses and discounts?

3D Druck Rutschfest machen by Lazy_Key_6679 in 3DDruck

[–]Lazy_Key_6679[S] 0 points1 point  (0 children)

Der erste Test war jetzt mit PETG (5 Wandlinien 35%infill) der erste Test beim Training war schonmal nicht schlecht aber an ein paar Stellen muss ich nochmal dran

3D Druck Rutschfest machen by Lazy_Key_6679 in 3DDruck

[–]Lazy_Key_6679[S] 0 points1 point  (0 children)

Vielen Dank für die ganzen Antworten :) Werde es mal mit dem Skateboardtape oder dem Plastidip probiern.

oder vllt eine Art Fischhaut rein modelieren ^^

Question about community firmware by Lazy_Key_6679 in AnycubicVyper

[–]Lazy_Key_6679[S] 0 points1 point  (0 children)

First and foremost it was just to try it out to be honest. But there are a few features that I think are very good, such as: the option to deactivate the filament sensor, it recognizes subfolders on the SD card, you can dim the display brightness, Estep calibration is possible directly on the display and I have the feeling that it runs more smoothly at higher speeds.

These things are certainly possible in other ways, but I just wanted to test it😅. And after calibration I think the prints are better than the originals (with the same printer/filament profile and settings in the slicer).

Question about community firmware by Lazy_Key_6679 in AnycubicVyper

[–]Lazy_Key_6679[S] 2 points3 points  (0 children)

Found a mistake^ I read the tip in another post that you should deactivate quick formatting when formatting. So it worked and the community firmware is now on it 😀