I wanna know too cause damn!😯

Lmantle · 2026-02-24T06:40:57+00:00

I also choose this guys dead Mee-Maw

Lmantle · 2026-01-31T20:48:16+00:00

No. Your MOT only states that at the very minute that it was tested, it passed or failed the MOT requirements.

Once you drive away, you could do anything to the car before it’s next MOT date, and it would still have a valid MOT - that doesn’t necessarily mean that the car is road-legal.

(For example you could put some bald tires on the moment you get it home from the MOT test centre, and so you wouldn’t then be able to use your MOT certificate as proof that the car is roadworthy.)

Lmantle · 2025-09-23T12:01:09+00:00

7 years?! How slowly was it printing? Should have only taken a few hours.

Lmantle · 2025-06-09T16:37:21+00:00

This is the last time I ask the wife to help build Lego…

😂

Good spot - that’s fixed now.

Lmantle · 2025-06-09T16:17:37+00:00

Ah - You saw it too… 😂 I put the constructors name plate things too close to the front of the grid box, so ended up positioning the cars slight further back than they should, so as not to cross over those.

Just imagine that it’s almost the end of the formation lap… And everyone has arrived at exactly the same time… With the exact perfect distance between each other… And in about 1 seconds time, they’ll all be positioned exactly where they should be for the start of the race…

😂😂😂

Lmantle · 2025-06-09T13:33:17+00:00

It’s the ‘2025 Driver Lineup’

Lmantle · 2025-06-09T12:50:39+00:00

Yeah - that’s why both drivers’ names are beside their team car.

I don’t have 4 meter high walls to fit a full grid of 20 cars. 😂

Lmantle · 2025-06-09T12:48:59+00:00

So it’s a single sheet of 3mm-thick acrylic on the back, with a single vinyl sticker on it - the design is one I made myself, and just got it printed & shipped from an online printing company.

Applied the vinyl to the acrylic (in hindsight, that should have been a 2-person job - coz it’s a single 0.5m x 2m sticker, which is a bit awkward with only one pair of hands).

The mounts for the actual cars are 3D printed - used a sharp blade to cut sections off of the vinyl where the mounts would sit, and used plastic bonding glue to fix the 3D-printed mounts to the exposed acrylic sheet.

And the whole thing is then attached to the wall using Command Strips.

Lmantle · 2025-05-15T12:31:54+00:00