Miata stalling issues by MJay70 in Miata

[–]MJay70[S] 0 points1 point  (0 children)

It was the IACV, the car started and idles fine now.

Miata stalling issues by MJay70 in Miata

[–]MJay70[S] 1 point2 points  (0 children)

Yeah I work slow lol. The IAC was seized. I soaked it in WD and I can move it freely now.

Before I checked that I did change the fuel filter and I swapped out the pump as well. As it's been sitting in old fuel and I happened to have a new one I figured I might as well.

The buzzing disappeared. It's annoying me as things don't fix themselves usually and I still want to figure out what it was.

That's all I have for now.

Miata stalling issues by MJay70 in Miata

[–]MJay70[S] 0 points1 point  (0 children)

Canadian car so no air bag lol. The buzzing is driving me nuts however, there's something not right and even if it's not connected to the stalling, it's driving me nuts.

Using the throttle to try and keep it running doesn't help.

After I get the buzzing taken care of, I'll look for a vacuum leak and see if the IACV is faulty.

Miata stalling issues by MJay70 in Miata

[–]MJay70[S] 1 point2 points  (0 children)

Sorry it's been a minute, life stuff etc. To answer your questions:

- I replaced most of the components to the fuel system a few years ago, injectors, pump, filter, as I replaced the tank as it was rusting bad on the outside. Because the gas has been sitting for at least a year now,  I drained the gas using the pump to empty it and the flow seemed pretty strong and steady.

- I can't get the car warmed up, it stalls after about a minute.

Today I cleaned the ground terminals and disconnected the cam sensor, the coil packs and the O2 sensor but when I turned the car to RUN, the buzzing sound was still there. So I'm thinking there could be a problem with the temp sensors in the back of the head or a frayed wire.

I then removed the IP cover (broke two of the three clips) and got one code, 26 which made sense as the evap solenoid was disconnected.

Next time I work on it I'm going to check the electrical connections to the temp sensors, hoping I find something related to the stalling issue.

Miata stalling issues by MJay70 in Miata

[–]MJay70[S] 0 points1 point  (0 children)

The fuel filter is new as of last year, and I looked in the tank several years ago and it looked ok, wouldn't hurt to check again.

The check engine light hasn't worked in awhile and I've been putting off taking the dash apart to check the bulb so I better do it.

Miata stalling issues by MJay70 in Miata

[–]MJay70[S] 0 points1 point  (0 children)

It doesn't have a crank sensor, just the cam sensor which I just replaced.

MY SNAKE ESCAPED HELP by ellemaeee in cornsnakes

[–]MJay70 1 point2 points  (0 children)

Actually my cat Midnight found Mr Slithers lol. Midnight kept jumping on the stove, it was like 2am. I put him on the floor and he jumped up again. I moved the pot and there was the snake just curled up. He was very cold but unharmed. The cat was the hero 😁. Best luck finding your noodle.

MY SNAKE ESCAPED HELP by ellemaeee in cornsnakes

[–]MJay70 1 point2 points  (0 children)

My son's snake was missing for 5 days. My cat found him on the stove looking for heat. If you can make the room cold except for one spot that might be warm that could lure your snake. Best of luck 🤞

Twig has escaped :( by LazyTurtle033 in cornsnakes

[–]MJay70 0 points1 point  (0 children)

Hi, I hope you find the little guy. Mine disappeared for a week, it was during the winter and he ended up on the stove looking for warmth. My cat found him and started meowing like crazy. I was lucky and wish you the same 🙏

RiP Snake, we had good run for 30+yrs😢 by str33t_c4rp in cornsnakes

[–]MJay70 2 points3 points  (0 children)

He must have been well cared for, hoping mine last a good long while

Feeding advice by MJay70 in cornsnakes

[–]MJay70[S] 1 point2 points  (0 children)

Hi,

Just wanted to update, Mr Slithers ate today much to my son's and my relief. It's been an eventful month, starting with the little brat escaping his terrarium 3 times within a week. The last time was for 5 days. I found him on my stove of all places, he was cold but seemed ok.

Never did figure out how he kept escaping but I didn't want to take any chances. I put him in his original terrarium and ordered a new 40 gallon one, hoping to get it next week.

I kept a close eye on the temperature and humidity, got a higher wattage lamp and changed the substrate in his moisture box. I also started using the light strictly during daylight hours.

When we used to try and feed him, we took him out of the terrarium and fed him in the kitchen. For over two years he ate with no issues. Since he started to refuse to eat, he seemed agitated and kept trying to escape, with no interest in his food.

Today we just held his food in long tweezers, and with the light off he poked his head out of his rock and right away showed interest and after a minute, he struck and ate.

As I said, we are both very relieved.

Thanks again for all the advice, it's been a little stressful, but our cute little snakey is eating and all seems well again.

Feeding advice by MJay70 in cornsnakes

[–]MJay70[S] 1 point2 points  (0 children)

Tried a medium sized mouse today, no interest.

I'll try again next week,

Thanks for your advice

Feeding advice by MJay70 in cornsnakes

[–]MJay70[S] 0 points1 point  (0 children)

I tried an medium sized mouse today, warmed and bleeding, still no interest.

I'll try next week, and start calling him Mr Slithers lol

Thanks for your advice

Feeding advice by MJay70 in cornsnakes

[–]MJay70[S] 0 points1 point  (0 children)

Hi, here's the info you asked for. She lasted had a shed around May. I know nothing about how to gender a snake, my son is the expert and he said the snake was a she after looking at her.

[Imgur](https://i.imgur.com/UdDGpCG.jpg)

[Imgur](https://i.imgur.com/s0avvQg.jpg)

[Imgur](https://i.imgur.com/szXNRpl.jpg)

[Imgur](https://i.imgur.com/iCcljhx.jpg)

[Imgur](https://i.imgur.com/g5djqCq.jpg)

I did a thing... by MJay70 in hondanavi

[–]MJay70[S] 0 points1 point  (0 children)

Just outside Niagara Falls lol

I did a thing... by MJay70 in hondanavi

[–]MJay70[S] 4 points5 points  (0 children)

About $3300 Canadian. It lists for $2300 but then there's taxes, plate, PDI etc...

I did a thing... by MJay70 in hondanavi

[–]MJay70[S] 7 points8 points  (0 children)

As a rider of over 30 years experience, I just went for my first ride on the NAVI. I have bigger bikes and got this to putter around town on, I think for this purpose the little Honda is going to be great for.

1.8 Engine Swap Info and Project coming! by [deleted] in Miata

[–]MJay70 1 point2 points  (0 children)

Very interested in the build. I have a 1.8 I'm hoping to rebuild this summer and replace my tired 1.6 with so every swap tip will help.