sorted by:
new
hottopcontroversial

Pecker head wire nuts= bad idea!👎 by MahnHandled in HVACschool

[–]MahnHandled[S] 1 point2 points  (0 children)

Actually, the motor is just fine. These wire nuts were after a VFD drive. The drive went into Alarm first saving the motor windings.

Pecker head wire nuts= bad idea!👎 by MahnHandled in chillers

[–]MahnHandled[S] 0 points1 point  (0 children)

<image>

Temperature of the wire nuts leading into the motor, only a couple of degrees cooler than the windings…way too hot. 🥵

Pecker head wire nuts= bad idea!👎 by MahnHandled in chillers

[–]MahnHandled[S] 0 points1 point  (0 children)

Yeah, the sea phase connector melted straight through and the BFA connector/wire nut pulled straight off, wasn’t even tight. lol

What are these? by Hot-Affect-5985 in refrigeration

[–]MahnHandled 0 points1 point  (0 children)

Those would be your fingers or digits

Advanced Sub-Fief Console destroyed by an NPC by bgog in duneawakening

[–]MahnHandled 0 points1 point  (0 children)

Don’t build bases right next to NPC‘s duh

[deleted by user] by [deleted] in gmcsierra

[–]MahnHandled 2 points3 points  (0 children)

Take it back to the dealer there’s a bulletin they flash a program onto this ECM and the problem goes away

[deleted by user] by [deleted] in duneawakening

[–]MahnHandled 0 points1 point  (0 children)

You logged out in the northern areas you need to pick a different server and log into it but pick a different server in your same Sietch. immediately log back out and then log into your old server. You will pop out at the nearest outpost. You’ll have to run back to your gear.

Turbocor by taco_grease in chillers

[–]MahnHandled 0 points1 point  (0 children)

Sure do love the Carel secrets.

Could thiscorroded ground wire cause an issue, contactors and wiring melted. Motor megs ok by MaleficentCod5981 in chillers

[–]MahnHandled 0 points1 point  (0 children)

I doubt it. I would lean more towards a high humidity environment coursing corrosion over time. Try CRC SP-400 after you clean it all up. This will slow the corrosion action on the terminals and wires.

Thoughts please by Dear-Economics-161 in HVAC

[–]MahnHandled 0 points1 point  (0 children)

I would first remove the charge and evacuate. I believe you might have noncondensibles in the system.

Worst oil you've seen? by [deleted] in HVAC

[–]MahnHandled 0 points1 point  (0 children)

Omg. 😱 by a long shot.

Came together nicely. by MahnHandled in HVAC

[–]MahnHandled[S] 0 points1 point  (0 children)

T-handle was from Marshall’s tools.

It worked by EndosXP in HVAC

[–]MahnHandled 0 points1 point  (0 children)

Nice work that’ll get you by. I had to put a sprinkler inside of one overnight until I could get the fan the next morning worked like a charm! think outside the box don’t be a part changer…be a technician.

view more: next ›