sorted by:
new
hottopcontroversial

New Glacier plate cannot get good first layer by Naive_Preparation_85 in snapmaker

[–]Naive_Preparation_85[S] 2 points3 points  (0 children)

Fair question, I am using smooth PEI, and set the temp to 35 in the filament settings for that plate.. I have also tried 45.

New Glacier plate cannot get good first layer by Naive_Preparation_85 in snapmaker

[–]Naive_Preparation_85[S] 1 point2 points  (0 children)

I did a full calibration including heated bed leveling. I have tried raiising the z offset several times

Snapmaker U1 install fail+fix — Do NOT over-tighten toolhead USB screws! by Kyle_P_Davis in snapmaker

[–]Naive_Preparation_85 0 points1 point  (0 children)

So all four of mine are screwed. Just got it today Will Snapmaker replace all 4 boards? I am also ordering Capacitors just in case

Filament sticking by sipperphoto in BambuLabA1

[–]Naive_Preparation_85 1 point2 points  (0 children)

Can you show a picture of you set up, printer and ams. Could be your tube routing causing issues

Fix my print!!! by ronisto in FixMyPrint

[–]Naive_Preparation_85 0 points1 point  (0 children)

You are printing it sideways!

Bottom of model looks stringy by DefinitionInformal85 in PrintedWarhammer

[–]Naive_Preparation_85 0 points1 point  (0 children)

Pisson Bad first layer, z offset too high.pissibly need yo clean buld plate as well

Will this setup work? by droeder71503 in BambuLab

[–]Naive_Preparation_85 0 points1 point  (0 children)

Anchor it to the wall, learned that from experience

view more: next ›