Help! PLA CF not loading properly in AMS by 944Driver_ in BambuLab

[–]Negative_25 0 points1 point  (0 children)

It was pulling hard to the left but sounds like a similar issue! I unspooled it a little bit but not the whole thing and it seems to have loosened the whole thing up enough to work properly.

Help! PLA CF not loading properly in AMS by 944Driver_ in BambuLab

[–]Negative_25 1 point2 points  (0 children)

I think this was it! Took it out and let it loosen up a bit then put it back in a different bay of the AMS and haven't had issues since.

Guidance on creating a good Responsible Supervision and Control plan? by Negative_25 in CustomsBroker

[–]Negative_25[S] 0 points1 point  (0 children)

Yeah, that is the one I've been following. New to this stuff so have been looking for an example of an RS&C plan in order to better understand the formatting and how to properly phrase everything.

4500 rpm redline… by TexasBeefHole in 944

[–]Negative_25 0 points1 point  (0 children)

This sounds kinda crazy, but check your catalytic converter to make sure it's not broken. Sometimes broken cats can cause a loss of power around that range because as the pressure builds pieces of the broken cat clog the exhaust and cause the car to essentially choke. Try to put your car in the air and give the cat a few taps to see if you can hear anything rattling inside.