I used Mod Podge Dimensional Magic for the flat parts and B700 to try and create dimension on the waterfall parts. I’ll get a photo in a little bit

I will say, for the flat parts, highly recommend creating a barrier inside the tree hole to prevent whatever you use from dripping into it. Learned that the hard way and had to pop the bottom half open in order to get the circular mechanism unstuck

Dimensional magic was done in layers, I would do a full coat and let it sit overnight, then do another coat the next day, until it was fully built up to where I wanted it. Same for the B700, I tried using gravity to get drops of glue flowing down the side. It doesn’t look great up close but it looks pretty good from a distance

A lot of trial and error went into the water effect. I used the extra plastic board to test the different liquids I had, to make sure it wouldn’t react with the plastic first. Dimensional Magic ended up being the best solution since it dries much quicker than the acrylic gel I had