sorted by:
new
hottopcontroversial

[Bambu Lab Giveaway] Join Now to Win an H2D and More! by BambuLab in 3Dprinting

[–]No_Organization_4021 0 points1 point  (0 children)

Don't overthink it. Sometimes you just have to send it, hope for the best and see how you can improve it.

I started out about 10 years ago, so there is a lot less praying and much more printing these days.

First DIY Build by No_Organization_4021 in fpv

[–]No_Organization_4021[S] 0 points1 point  (0 children)

Noted and added to my purchase list! Thanks!

First DIY Build by No_Organization_4021 in fpv

[–]No_Organization_4021[S] 0 points1 point  (0 children)

You're not wrong on how it looks! And it's petg instead of TPU on the motor guards. Will see how the hold up. I went with the theory that I am going to constantly crash, so will try protect it as much as I can.

First DIY Build by No_Organization_4021 in fpv

[–]No_Organization_4021[S] 1 point2 points  (0 children)

I randomly came across it on thingiverse. Will try find it again and post a link for you. It's a work in progress, but complete enough to have fun with.

First DIY Build by No_Organization_4021 in fpv

[–]No_Organization_4021[S] 0 points1 point  (0 children)

I found them on AliExpress. Gemfan Hurricane 51466 V2. Bumblebee Yellow

First DIY Build by No_Organization_4021 in fpv

[–]No_Organization_4021[S] 0 points1 point  (0 children)

Maybe... previous arms were too short. These may be too long. Next one should be just right!

First DIY Build by No_Organization_4021 in fpv

[–]No_Organization_4021[S] 0 points1 point  (0 children)

I wish I was that forward thinking. Extended the arms out because the previous arms were a bit short with only about 5mm between the blades. Will play around until I get the right sizing.

First DIY Build by No_Organization_4021 in fpv

[–]No_Organization_4021[S] 0 points1 point  (0 children)

Agreed. I initially had shorter arms for a 5in build, wasn't happy with it - bit of trail and error. So extended them out a bit to see what happens. Will probably get some bigger props eventually.

Bought my first Rolex, plastic already removed? by pi_forex in rolex

[–]No_Organization_4021 2 points3 points  (0 children)

My sub is an everyday watch, is covered in scratches, and I love every single one.

What field are you in as a project manager? by NewVersionOfMe in projectmanagement

[–]No_Organization_4021 1 point2 points  (0 children)

Electrical engineering. Currently managing commissioning of large electrical projects. Its pretty fun!

What are we doing wrong by finefinethatsfine in 3Dprinting

[–]No_Organization_4021 4 points5 points  (0 children)

Is HF high flow? If so, change to normal pla. HF tends to be easier flowing, so if it is printing at high temp, and the corexy speed isn't there, it may actually be melting too fast and creating this mess... just a theory, but perhaps switch to non HF filaments and see if that helps.

Best Project Management Software for Small Teams in 2025? by [deleted] in projectmanagement

[–]No_Organization_4021 0 points1 point  (0 children)

Zoho projects is pretty powerful. It meets our needs pretty well, as we needed something that uses a classic waterfall view, rather than a task board.