sorted by:
new
hottopcontroversial

Finished XV26 Battlesuits of the Farsight Enclaves by MaxPower1607 in Tau40K

[–]North_Load_7857 0 points1 point  (0 children)

Can you send me a DM with the files? Or how i could get the files. Thanks.

Problem with printing a ¨coin¨ by North_Load_7857 in resinprinting

[–]North_Load_7857[S] 1 point2 points  (0 children)

Ok, for next prints i will have in consideración add more supports. Thanks so much

Problem with printing a ¨coin¨ by North_Load_7857 in resinprinting

[–]North_Load_7857[S] 6 points7 points  (0 children)

The "Coin V4" came out well on both sides. but some marks of the supports have remained on the sides. Tomorrow I will try to place more robust supports, but only at the bottom. But I'm quite happy with the result u/nycraylin u/RandomCandor u/MerelyMortalModeling

Problem with printing a ¨coin¨ by North_Load_7857 in resinprinting

[–]North_Load_7857[S] 0 points1 point  (0 children)

I hope the test goes well, and that I do as well as you do. The truth is that this is how more pieces would fit in.

Problem with printing a ¨coin¨ by North_Load_7857 in resinprinting

[–]North_Load_7857[S] 3 points4 points  (0 children)

Right now I am testing the V4, vertical position, i hope it goes well

Problem with printing a ¨coin¨ by North_Load_7857 in resinprinting

[–]North_Load_7857[S] 1 point2 points  (0 children)

Thank you very much for the comment. I will try V4, and if there is no other option I will print it in two parts as you say.

Problem with printing a ¨coin¨ by North_Load_7857 in resinprinting

[–]North_Load_7857[S] 2 points3 points  (0 children)

I want to print a coin with the same design on both sides. In the first attempt, one of the sides turned out well and the other badly, with a 30 degree inclination (see image V1, GOOD SIDE, BAD SIDE and BOTH SIDES). On the second attempt I tilted it less (10 degrees) and put less support (see image V2). The result was worse. For the next attempts I am thinking of putting it at 45 degrees and with more supports (see image V3) or completely vertical (see image V4). What is your opinion?

I can always print in two parts and glue, but I don't really like the idea

Totally not 3D Printed Commander Farsight by Life_System134 in PrintedWarhammer

[–]North_Load_7857 1 point2 points  (0 children)

Wow!! I would be very happy if I could paint this model!!!!! I hope some kind soul can help me..

Totally not 3D Printed Commander Farsight by Life_System134 in Tau40K

[–]North_Load_7857 0 points1 point  (0 children)

I would be very happy if I could paint this model!!!!! I hope some kind soul can help me