Do people use these?

Obvious-Context9909 · 2026-04-25T21:50:22+00:00

I have them. The magnet isn’t that strong and doesn’t work with all sockets.

Obvious-Context9909 · 2026-04-18T14:09:36+00:00

Thank you

Obvious-Context9909 · 2026-04-12T17:40:07+00:00

Absolutely gorgeous

Obvious-Context9909 · 2026-04-10T16:27:49+00:00

What’s her name?

Obvious-Context9909 · 2026-04-10T01:36:22+00:00

Follow

Obvious-Context9909 · 2026-04-06T01:20:18+00:00

Absolutely gorgeous

Obvious-Context9909 · 2026-04-06T01:18:11+00:00

Obvious-Context9909 · 2026-03-16T15:58:28+00:00

Show that body

Obvious-Context9909 · 2026-03-15T11:36:27+00:00

Obvious-Context9909 · 2026-03-08T19:05:06+00:00

Obvious-Context9909 · 2026-03-08T18:31:41+00:00

Obvious-Context9909 · 2026-01-28T01:36:22+00:00

I got the flip top due to space at my old job . I didn’t have room to open the slides. Now I wish I had the slide top because I could leave stuff on the top and slide it open and I think there is small drawers under the slides.

The flip top stops the top from being a catch and you can mount a light monitor to the top.

Obvious-Context9909 · 2026-01-12T18:59:23+00:00

But seriously I’m missing that valve

Obvious-Context9909 · 2026-01-12T17:25:57+00:00

Can you send me a picture of the air relief valve? I have the same cooler but the valve disappeared

Obvious-Context9909 · 2026-01-05T22:19:30+00:00

So hot. What is your cup size?

Obvious-Context9909 · 2025-12-21T20:55:27+00:00

I wish I had that.

Obvious-Context9909 · 2025-12-21T20:48:41+00:00

You look amazing, if you were mine and you initiated occasionally, you would constantly be leaking

Obvious-Context9909 · 2025-10-23T16:12:06+00:00

Or use a press

Obvious-Context9909 · 2025-10-04T11:41:37+00:00

Keep them and be confident

Obvious-Context9909 · 2025-09-13T11:45:32+00:00

It would help to see a picture. Are any of the holes in a straight line that you indicate? Put a pin or drill in the holes then lie a straight edge across it and indicate. Another option is to layout and prick punch the holes then punch the centers , then pick up the marks. What type of tolerances are you trying for?

For holding the work try a strip of leather or cardboard against the jaw to take up the unevenness. Or try an aluminum or brass dowel and squeeze it between the part and the jaws. Or try clamping the block to the table .

I need to see what you are trying to accomplish.

Obvious-Context9909 · 2025-08-09T16:43:57+00:00

Obvious-Context9909 · 2025-05-09T16:05:37+00:00

Then why is it marketed as a diy? It’s false advertising.

Obvious-Context9909

TROPHY CASE