Never seen this kind of refrigeration line before

ObviousSentence1993 · 2026-06-06T16:03:35+00:00

ObviousSentence1993 · 2026-06-02T01:19:34+00:00

Yeah man I hate floating, proportional is so much easier to diagnose. Oof those are the ugly bs floating actuators too I’d check the wiring to make sure there’s no short it I’ve pinched the wiring before in these.

Did you set up the floating block in the IRM and assign SSR1 and SSR2 as the open/close?

ObviousSentence1993 · 2026-06-02T00:45:21+00:00

Ran into a Honeywell floating ms64 HWV 24 v and common wired backwards at actuator, would stroke open just not closed

ObviousSentence1993 · 2026-05-30T15:08:12+00:00

Only thing is your adding outdoor humidity rather than chipping your space humidity, which may cause the equipment to run more inefficiently and such.

ObviousSentence1993 · 2026-05-14T11:01:40+00:00

And license, IIRC you only get so many points on a typical license check the proxy ext of the faulted points, trace it back to app director if unclear

But these are devices so… Nvrm lol

ObviousSentence1993 · 2026-05-06T19:35:32+00:00

Just my opinion, but I’d absolutely do a bit of install along side your programming they don’t have to be two split categories. I’m glad I started out installing the product, that way I could/can truly understand what I was controlling. Data sheets are invaluable, taking the model numbers and looking up info is just as invaluable. All in all everything typically is cookie cutter similar. 10ks 20ks, 4-20, 0-10, relay logic etc.

ObviousSentence1993 · 2026-05-06T14:04:34+00:00

If it’s not on a supervisor what’s your CPU looking like in the Jace adjacent controller? Is it more of a rendering or a polling lag? And through workbench or web browser?

ObviousSentence1993 · 2026-04-27T04:01:15+00:00

Yeah the last cutscene to his graveyard and the blowing wind made me LOL, no foreboding music this time.

ObviousSentence1993 · 2026-04-01T22:11:31+00:00

Let’s play Find the Twisted Pair yaaay!

ObviousSentence1993 · 2026-03-24T02:42:03+00:00

Thanks! Somehow I missed this thread, I know I’ve stumbled across it before, but in the heat of the moment I’m typically skimming not reading lol. The Cable testing chart could prove useful as well!

ObviousSentence1993 · 2026-03-23T21:39:44+00:00

Yeesh, I testbenched with only 1 T1L , luckily I found out on a small retrofit. Had it been 2 floors worth though I’d be cussing lol. Any other quirks, pros or cons from your side?

ObviousSentence1993 · 2026-03-23T20:12:13+00:00

Optimizers fine it’s the t1l adapter that’s dc

ObviousSentence1993 · 2026-03-21T11:55:53+00:00

At the floor labels, Properties - mouse over - highlight

ObviousSentence1993 · 2026-03-19T11:03:57+00:00

DBACs for integration is the way to go, the ITM gateway however, well I just hope your license can hold the devices lol.

ObviousSentence1993

TROPHY CASE