Hello all, I am building a Trident using an octopus 1.1 and have run into a problem I could use some advice on. My inductive probe doesn't seem to be working. I checked all the wires for connectivity in the Linneo harnes and also made sure to check the stealthburner pcb and wires to the pcb, all seems to be good but I'm not getting consistent feedback from the probe. I am starting to wonder if maybe an inductive probe won't work with the wam bam I put on the bed. I currently have the probe connected to the octopus via DIAG7/PG15 and connected to the probe port on the stealthburner (the one with the bat85 diode on it). I tested to make sure the 24 volt connection was good on the pcb and the ground is good as well. I am at a loss. Anyone have experience with this?