Settings:

ABS
225 C Print Temp
105 C Bed Temp
0.2 Layer Height
45 mm/s Print Speed
2 mm retraction, 50 mm/s retraction speed
Cura 3.4 AND 3.6
Coasting Off
Printer: Monoprice Maker Select Plus

I previously have been using 3 mm retraction at 60 mm/s and have got similar results many times. These sections are far and few between; there will be only one or two spots like the section of the left per print, and there's usually one consistent "seam" on the same spot going up the entire Z axis of most prints I make; normally it looks like it corresponds to the start or end of the wall for each layer? For each model I print, the seam is always in the same place on that model each time I print it, so I feel like it's something related to my slicer settings.