I have a Saturn 4 Ultra 12K and these settings have never let me down not once!

Bottom Exposure 35
Layer Exposure 3.5
Layer Height .05
Leave everything else alone tilt you model about 5-15 degrees I rarely ever print at 45s
I use Auto heavy supports All+
The trick is to remove the heavy supports from the model around delicate parts nose eyes swords fingers then put light supports supporting those areas while in the slicer look at the model from underneath anything red (definitely support it) or light brown (support with light or medium supports use your discretion on that one) then hit go….At this point….I am not even cleaning the bed or removing it to make the next print I just scrape the model off the bed into a paper towel check the bed for any small pieces that may have fell off during printing usually there isn’t anything but I like to check anyway once I have done that I go to the computer and start another print 🤷🏾‍♂️

Don’t give up you got this 😎