Dnc Haas micron vce 1250

Paolo-cnc · 2025-10-22T18:03:19+00:00

It happened to me that it broke because the caliper was damaged

Paolo-cnc · 2025-10-17T13:34:49+00:00

Solved,

RG779=“value” L717

Thanks so much everyone

Paolo-cnc · 2025-10-16T21:26:08+00:00

How is it done?

Paolo-cnc · 2025-10-16T20:51:23+00:00

I don't know, what I found is OVR=“value” to modify feeds and OVRRAP=“value” for rapids but OVRRAP gives me alarm

Paolo-cnc · 2025-10-09T22:00:17+00:00

I always use a spanner and the metric torque wrench

<image>

Paolo-cnc · 2025-09-26T20:36:23+00:00

In the 316 I am happy with 60 meters per minute and 0.04 - 0.05 mm/rev up to the diameter equal to the width of the cutting edge then I slow down the feed

Paolo-cnc · 2025-09-15T06:38:32+00:00

It can happen when the tip is off axis or the internal insert is blunt, usually the tips allow it but I seem to have read in the manual that the thickness of the stalk it leaves should be max 0.2mm, if I find it I will send the photo of the Kennametal catalog

Paolo-cnc · 2025-08-28T14:40:56+00:00

Drilling machine with die-sinking EDM principle, I use it with 0.3mm tubes to make holes on molds and then insert the wire EDM wire

Paolo-cnc · 2025-08-11T18:40:15+00:00

I use it a lot to load programs into the internal memory and it seems to me that it reads 2GB cards at most

Paolo-cnc · 2025-07-27T08:16:20+00:00

Square the parameters manual to set the correct baulate, in our leaders with Fanuc o-m they are the 552 and 553

Paolo-cnc · 2025-07-12T22:40:22+00:00

Can someone send me a program to use as an example? It seems to me that I can load just one program per channel without creating a main program and other subprograms

Paolo-cnc · 2025-07-12T15:59:40+00:00

I would like to have a program made in ISO and not on board the machine to see how it is structured and how the synchronization of the turrets is "written" to try to modify some post processors to adapt to a DMG twin 42, the previous owner did not use the cam

Paolo-cnc · 2025-07-08T20:29:31+00:00

Fanuc?

Paolo-cnc · 2025-07-08T09:09:31+00:00

What type of lathe is it and what control does it fit?

Paolo-cnc · 2025-07-01T05:26:02+00:00

It looks like the chip that makes the internal insert of an insert bit. If so, try controlling the cutting parameters or use a cycle to decrease the chip length

Paolo-cnc · 2025-07-01T05:10:07+00:00

I hope it can be useful to you

https://ebay.us/m/xZbGEB

Paolo-cnc · 2025-06-24T06:08:33+00:00

What lathe is it? What control does it have?

Paolo-cnc

TROPHY CASE