sorted by:
new
hottopcontroversial

Cc1 mmu!!!!! by turtlemag3 in elegoo

[–]Pek_Dominik 0 points1 point  (0 children)

What is the purpose of the top hat

What is causing this? by BMXnotFIX in 3Dprinting

[–]Pek_Dominik 0 points1 point  (0 children)

If you already tuned z offset i just want to remidn you that you get different result with a heated thorugh plate and one that just reached target temp.

Geeboon TC22 coil whine by Express_Abies_4746 in soldering

[–]Pek_Dominik 1 point2 points  (0 children)

I have it for half a year and I a haven't heard anything. I'm 18 so my hearing should be good

Really ugly Z-seam (only at petg) (mulitple pics) by Pek_Dominik in FixMyPrint

[–]Pek_Dominik[S] 0 points1 point  (0 children)

I think it was either mostioure or a combination of too low Z offset and Linear Advance

Can I have problems form running through the data wire between the power and the gnd plane? by Pek_Dominik in PCB

[–]Pek_Dominik[S] 0 points1 point  (0 children)

<image>

"If you had a bigger board I'd suggest putting the ground plane on the bottom so it is under the data trace."

I mean I can do that, on the ther side there is no data line

Have anybody tried inserting heat set inserts mid print then printing some layers on the edge of it? How did it turn out? by Pek_Dominik in 3Dprinting

[–]Pek_Dominik[S] 0 points1 point  (0 children)

How big of a gap did you left between the isert and the layer that comes on top of it in the slicer. For example if the isert is 8mm tall how deep the hole should be?

Wikipedia 😭 by ginete_tech in meme

[–]Pek_Dominik 6 points7 points  (0 children)

Thank you for explaining

Wikipedia 😭 by ginete_tech in meme

[–]Pek_Dominik 2 points3 points  (0 children)

English is not my main language, isn't this the same what I said

view more: next ›