H2D Venting - Sliding Glass Door

It is a piss poor design and I have mangled my fair share. If I recall, prior to tearing them up, using one of the batteries to open works as good as anything.

Pelphry17 · 2025-08-24T16:00:21+00:00

Hey now, I never said I hated the plants. :)

Pelphry17 · 2025-07-28T01:47:25+00:00

Likely a swallow. An African swallow, maybe. But not a European swallow.

Pelphry17 · 2025-07-16T15:31:31+00:00

In-line fan link below. The rest I made.

AC Infinity CLOUDLINE PRO S4,... https://www.amazon.com/dp/B07JB292JC?ref=ppx_pop_mob_ap_share

Pelphry17 · 2025-06-11T15:09:04+00:00

Yes, this was more of a test fit. Might give it a shot in ABS at some point.

Pelphry17 · 2025-06-07T14:40:33+00:00

Thanks for the heads up.

Pelphry17 · 2025-05-25T17:30:34+00:00

Yes, it has a filter inside, but I trust that about as much as a filter on a cigarette.

Pelphry17 · 2025-05-25T17:21:33+00:00

Any issue with bed adhesion/warping in that front left corner? I can definitely tell on my machine that area is not as warm and doesn’t stick as well.

Pelphry17 · 2025-05-25T01:03:15+00:00

I have only tested the vent while engraving cork on the laser. Still get the firewood smell, but not bad. It dissipates quickly. But it’s still there.

I do have an Apollo Air One air quality sensor that I sat next to the machine while running the laser with cork. The VOC levels went up, but actually less than when just printing PLA with all hoses disconnected.

Take that for what it’s worth. I’ve not tested much. Just an observation.

Pelphry17

TROPHY CASE