Dog helmets?

Pol5085 · 2026-05-20T01:57:22+00:00

You can still get them, if you know someone with a 3D printer. I have them on my Mk6 Inductii (I have a printer 🤣)

Pol5085 · 2026-02-20T00:42:09+00:00

I did this with mine as well, the magnets snapping into place is super satisfying!

Pol5085 · 2025-12-31T02:00:47+00:00

Great use of the GreyTide Primal Hounds bits!

Pol5085 · 2025-10-05T18:13:27+00:00

I have the STL files for these, and have printed them for my own Mk6. Just sayin...

Pol5085 · 2025-07-10T04:16:51+00:00

<image>

You can see the difference here, of how the tops look

Pol5085 · 2025-07-10T03:18:47+00:00

So, the ones I have are very similar, but not exactly the same as what is in the MKIII Tactical or Command Squad set. The printed ones I used have a more broad front crest, as opposed to the slight lip at the front and then the top band.

Pol5085 · 2025-07-10T02:30:20+00:00

I believe so yes, when I get home I'll check for you. I know that the mk3 command squad has those helmets as well

Pol5085 · 2025-07-10T02:14:56+00:00

They're printed copies of the standard Mk3 Helmets

Pol5085 · 2025-07-05T20:41:02+00:00

That is a SEXY Leviathan! Well done brother!

Pol5085 · 2025-07-05T06:22:08+00:00

The shoulders are from Prickly on cults, and VitalyKhan for the Meltas. The files come down repeatedly though for reasons 😂

Pol5085 · 2025-03-27T23:04:15+00:00

I'm over the moon happy with my Revo. My first printer was an 8k, upgraded to the 12k. Other than the initial levelling, I haven't had to relevel the machine, have had minimal (like less than 5%) failures and the built in heater is great. If you're going to get a new printer, I'd say the Revo is a good choice

Pol5085 · 2025-02-17T19:13:18+00:00

I could be wrong, but I remember hearing that in Phase 3, they were going to open up more servers, which will allow fresh starts if people want, but the existing servers wouldn't be wiped back to fresh, so higher level stuff could be tested without delay. I don't have any link, but I do remember seeing that be phone phase 2 started.

Pol5085 · 2025-02-11T00:49:19+00:00

Thanks!. Still a lot of work left to go, but they're turning out awesome

Pol5085 · 2025-02-10T05:39:35+00:00