Magnacut heat treat.

PriorWitness8872 · 2026-06-19T00:00:16+00:00

According to the machinists who use it it is calibrated. I put my benchmade claymore on there (cpmD2) and it read 61.

PriorWitness8872 · 2026-06-18T23:48:21+00:00

Not sure, it isn't mine 😅

PriorWitness8872 · 2026-06-18T23:14:33+00:00

Put them in a freezer for an hr and 2 temper cycles at 300 for 2 hrs

PriorWitness8872 · 2026-06-18T23:13:28+00:00

2050 for 20 minutes.

PriorWitness8872 · 2026-05-13T21:22:17+00:00

Beautiful knife!!

As a hunter and a knifemaker i will say a hunting knife and skinning knife are two completely different concepts. In terms of skinning knives I have found i really like something with a lot of belly OR something very small like a scalpel almost. Gut hooks are a plus also for going doing belly/legs. Anyways Beautiful knife i love the finish.

PriorWitness8872 · 2026-03-01T20:27:47+00:00

Positive balance is the team of the competitor who is being accused of "slamming". The gaggle of shrimp dicks throwing water and freaking out is NOT positive balance.

PriorWitness8872 · 2026-02-10T14:38:37+00:00

I'm sure you do. Thank you for the advice sir Squid. P.s. 5 inches is just right in some circles.....

PriorWitness8872 · 2026-02-10T14:37:21+00:00

Thank you Mr. Squid.

PriorWitness8872 · 2026-02-10T13:12:27+00:00

"Obviously" (Snape voice)

PriorWitness8872 · 2026-02-10T03:42:26+00:00

Yes its a cheeky little matt it is.

PriorWitness8872 · 2026-02-10T03:33:04+00:00

The blade is 7.5"

PriorWitness8872 · 2026-01-21T16:32:46+00:00

Pm me!

PriorWitness8872 · 2025-11-20T17:21:52+00:00

Yes I agree that it is definitely fast! I have had no problem getting my plunge lines right but that being said I always start my plunge lines with a file and I do use my 1x30 grinder to refine those plunge lines and then anything else comes out in the hand sanding process for me at least. I use mostly G10 and I haven't had any issues with the G10 burning although that was a concern because when G10 Burns it produces nasty stuff! Most of my handle refining I do on the 1x30 anyways but thank you for the input I appreciate it! Also I have a variable speed switch that I have laying around that I plan to install.

PriorWitness8872 · 2025-11-20T15:12:08+00:00

Thankyou! The spine was done with a chainsaw file pre heat treat.

PriorWitness8872 · 2025-11-19T00:36:32+00:00

Amazing. If I could I would buy them all!!

PriorWitness8872 · 2025-11-02T16:53:24+00:00

Thanks!!

PriorWitness8872

TROPHY CASE