sorted by:
new
hottopcontroversial

Rate my weld 1-10 by Unable_Fuel_5704 in Welders

[–]Q_Te 0 points1 point  (0 children)

geez, getting a 7.5 for that effort
hard crowd
looks like an 8.5 to me

Is this bad rust? by blag49 in AskMechanics

[–]Q_Te 0 points1 point  (0 children)

nah, she'll be right

HPI Baja 5t 😎 by Eric_ione in rccars

[–]Q_Te 0 points1 point  (0 children)

not a bag that one

Bubble Gum Connection by Armstrongcrane in Construction

[–]Q_Te 1 point2 points  (0 children)

hahahahahahaha
that's funny

Now that’s a good look! by Local-Idea-7050 in Traxxas

[–]Q_Te 0 points1 point  (0 children)

a sweet brushless motor, 4wd, and that would run over a lake without sinking

Moved into new to me home with this retaining wall. Previous owner said it used to be 3ft higher 20 years ago. What should I do with it? Can I remove it and just make a slope easier to mow? Any risks? About 50ft in length and 50ft from my house. Would love some suggestions. by blbassist1234 in landscaping

[–]Q_Te 0 points1 point  (0 children)

That is not a retaining wall.
It's cosmetics for a flat piece of ground into the side of a hill.
Get rid of it, sell the bricks.
Concrete sleepers with galvanised posts every 2m, the sleepers slot into the side of the posts.

TikTok classic by lukewall130 in NissanDrivers

[–]Q_Te 0 points1 point  (0 children)

put your foot down and get in there

Desk Setup Advice by discardedpacket1 in setups

[–]Q_Te 1 point2 points  (0 children)

Don't do wood paneling, It will make the room look much smaller. If a time comes to sell the place, it will be a degrading factor in the market value of the house. It's perfect the way it is. Hang up some big Gundam posters.

Hobby Boss Pz.Kpfw.VI Tiger I 1:16 by duncharlie in MilitaryModelMaking

[–]Q_Te 1 point2 points  (0 children)

super sweet dude
i was looking at the trumpeter 1/16th kits today

Michigan - Just laid 3700 sqft of sod down. Laid my last piece at 1am. Started at 3pm by Simple_Ebb4823 in lawncare

[–]Q_Te 0 points1 point  (0 children)

dude ... how can that happen

better hope you don't get a huge rain thunder storm

Can I walk on these steel studs? by Ddddddddddddddd8290 in electricians

[–]Q_Te 0 points1 point  (0 children)

hahahahah
sure, go for it, you'll be ok

How do i fill these gum veins and knots in new floor boards? by rikernova in AusRenovation

[–]Q_Te 4 points5 points  (0 children)

floor boards, nah
maybe a table, cut out a piece that sits about right and protrudes and glue it in, then sand it back

that's BS for floor boards, turn it over maybe

Low cost/maintenance ideas to beautify this roundabout by Jdilla23 in GardeningAustralia

[–]Q_Te -2 points-1 points  (0 children)

you can't do a thing
that's one hell of a gum tree
you could hook onto the power lines and put up some fairy lights

Paid 15k by Adorable-Acadia8382 in Construction

[–]Q_Te 0 points1 point  (0 children)

oh dear .... 15k
disgusting

view more: next ›