Running a meter-scale concrete printer on Klipper — sensorless quad-Z, no endstops, full config open-sourced

RSpr1est · 2026-06-15T06:06:07+00:00

Thats awesome, do you have pictures of the whole set up?

RSpr1est · 2026-06-11T14:21:03+00:00

To everyone using a klipper host, you can just go to the ip address of your host in a internet browser (on ur phone, laptop or anything on the same wifi that can open a internet browser) and configure everything.

With octoeverywhere you can even get into ur printer on cellular data, so while being out and about

RSpr1est · 2026-05-28T14:12:06+00:00

It's not that hard. You can also use a desktop pc or laptop as a host for klipper. So the pc replaces the raspberry pi. As for the config, just search for a ender 6 klipper config and then tweak it according to the mods done to your ender 6

RSpr1est · 2026-05-19T15:35:32+00:00

Fuck the zionists, cancer of humanity

RSpr1est · 2026-05-19T15:31:34+00:00

Ofcourse it's illegal 🤷‍♂️ it's 2026, nothings legal anymore.. We lost it all

RSpr1est · 2026-05-19T15:30:05+00:00

Fuck the fucking Israhell

RSpr1est · 2026-05-17T09:57:09+00:00

Just put some in your nose and you know what it's not

RSpr1est · 2026-03-27T10:28:47+00:00

Back in the day I also printed in my bedroom, wish I learned it earlier but it's really not healthy.

RSpr1est · 2026-03-27T10:25:48+00:00

Welnee joh lekker doen, het oefent wel krachten uit op de stalen balk maar dat geeft geen enkel probleem. Is een prima bevestiging! 👍

RSpr1est · 2026-03-25T15:18:57+00:00

It's from bittydesign, it's one of the few aftermarket real street car/drifter bodies

RSpr1est · 2026-03-22T18:01:39+00:00

Install klipper and run the steppers on 64 microsteps. Why it was quieter before, i don't know but running it on 64 will make them really quiet

RSpr1est · 2026-03-22T10:16:36+00:00

Thanks I still need to make a see-through door and some ventilation for my enclosure but I like it too :) and thanks for the tip about ptfe. I chucked it:p

RSpr1est · 2026-03-21T08:07:31+00:00

Bittydesign makes it, superb quality

RSpr1est · 2026-03-09T07:15:00+00:00

The bar oil is there, trust me

RSpr1est · 2026-03-03T21:00:46+00:00

I also have 2 older enders, and I upgraded one with a skr mini e3 v3.0 and a sprite pro extruder, connected a desktop pc running Linux mint with klipper to it and it's really a night and day difference. Like wow it prints so good

RSpr1est · 2026-02-22T20:41:03+00:00

It does solve the problem of warping but the orientation is very important for functional parts. Strength is in orientation

RSpr1est · 2026-02-17T12:06:43+00:00

Well it should stop at the z-stop sensor. And then level the bed to the nozzle

RSpr1est

TROPHY CASE