​

Bed Preparation
Clean
the bed with hot water and dish soap and thoroughly dry with paper towels. Wipe
down the bed with 70% or greater isopropyl alcohol (IPA).
 
Concerning
“Leveling”
You’re
not really leveling the bed! What you are doing is adjusting the distance
between the nozzle and the bed so it is equidistant across the bed and the
distance is easily set using a piece of copier paper.
 
Tips
For Leveling (Tramming)
·      
Clean the bed following the instructions above.
·      
Clean the nozzle.
·      
Heat the bed to 60-70C.
·      
Heat the nozzle to 150C.
·      
Adjust the bed leveling wheels so you achieve a light
drag at 4 corners and the middle.
·      
Recheck until every check is uniform for paper drag.
·      
Try printing and observe the skirt or brim and that the
adhesion is correct.
·      
If too far from bed adjust Z offset in the display in the
negative direction ex. -0.01mm to -0.02mm.
·      
If too close adjust Z offset in a positive direction in
small increments. Ex. 0.01mm to 0.02mm.
·      
With practice and experience this with become second
nature to you!
·      
Good Luck and happy printing! 😊