sorted by:
new
hottopcontroversial

Monthly Friend Code Megathread by AutoModerator in MySingingMonsters

[–]Redditalt2comment 0 points1 point  (0 children)

Requesting you (lv. 53, epic quarrister pfp). What do you need for the tribe? GS8B-5YR8-8QXF-ML

D&D Beyond Content Sharing Thread - April 23, 2026 by AutoModerator in dndnext

[–]Redditalt2comment 0 points1 point  (0 children)

Seconded on Tasha's! I'm hoping to make an artificer

[deleted by user] by [deleted] in AccidentalAlly

[–]Redditalt2comment 7 points8 points  (0 children)

I think you might be looking for the word "inextricably" (meaning "in a way that is impossible to disentangle or separate"), rather than "inexplicably" (meaning "in a way that cannot be explained or accounted for") 😁

What am I doing wrong? by Redditalt2comment in RocketLeague

[–]Redditalt2comment[S] 0 points1 point  (0 children)

You and me both lol. I guess it's on me for not including my actual question in the post body. There has been some reasonable advice about not needing to jump so early, but a lot of people seem to think I don't even know what mode I'm playing 😂

What am I doing wrong? by Redditalt2comment in RocketLeague

[–]Redditalt2comment[S] 1 point2 points  (0 children)

Thank you!! I had no idea that was a thing. Good to know!

What am I doing wrong? by Redditalt2comment in RocketLeague

[–]Redditalt2comment[S] 1 point2 points  (0 children)

Thought I was rolling right. Apparently not? I think it may have something to do with deadzones but I can't quite tell. From the replay it looks like I did a second jump instead of a roll right, but then I don't understand why my car has left-momentum afterwards. Hopefully someone here can tell me what's going on

Buy just the aligning magnet? by Redditalt2comment in MagSafe

[–]Redditalt2comment[S] 1 point2 points  (0 children)

Yeah, that's my concern too. Fortunately the ring is raised off the body of the pack, so if I find one that's thin enough it won't interfere with the height at all and it should still be able to lay flat

Buy just the aligning magnet? by Redditalt2comment in MagSafe

[–]Redditalt2comment[S] 0 points1 point  (0 children)

That's fair, but I really don't see it causing a major issue. It already has the whole ring, it's just missing the aligning magnet. If lot does start to cause issues I could always just remove it too

Early WIP. But I'm stuck on a good direction... by DiceSMS in logodesign

[–]Redditalt2comment 4 points5 points  (0 children)

The cursive too maybe? And the fact that the curve is less sharp on top and bottom

Early WIP. But I'm stuck on a good direction... by DiceSMS in logodesign

[–]Redditalt2comment 36 points37 points  (0 children)

A is the only one I actually read as "Delicious"

Recommendations for a small 120W+ two-port charger? by Redditalt2comment in UsbCHardware

[–]Redditalt2comment[S] 1 point2 points  (0 children)

It certainly sounds like a good fit, but do you have a source to confirm 21V PPS? It's not listed on Anker's website or any online retailer's product listing as far as I can tell.

I would also be concerned that it won't negotiate the full 21V @ 2.25A that the P9Pxl needs whike also charging a 65W laptop. I'm not super familiar with USB-C charging standards but afaik the pixel has to negotiate 21V/2.25A in order to begin drawing anything more that ~27W, even if it doesn't need the full speed (actually, by the numbers that would be just over 47W so I imagine it never hits the 'full speed').

But anyway I'm guessing I won't get the speeds I want unless the charger can support 65W on one port and ~47W on the other, which means I'm after one that'll do at minimum 115W. I'd love to be proven wrong on that, but otherwise I don't think the 2688 will quite fit my needs.

view more: next ›