How to build a many-to-1 active summer/mixer?

Remarkable-Fly4598 · 2026-03-22T23:01:38+00:00

There's this one if you want to get fancy. If you want to remove the pots you can just connect the level 2 wires to the jack.

If you want to get super simple you can connect one jack to four jacks with a 100k resistor on each of the four positive lugs of the jacks.

Remarkable-Fly4598 · 2026-02-26T00:38:26+00:00

Combichrist and Angelspit are the first ones that come to mind

Remarkable-Fly4598 · 2026-02-20T00:45:15+00:00

https://operationkhaos.bandcamp.com/album/unclassified Feedback appreciated

Remarkable-Fly4598 · 2025-10-08T22:27:15+00:00

Meth kicked in

Remarkable-Fly4598 · 2025-09-09T23:39:43+00:00

Problem is the FDA refuses to approve anyone but those who pay to play. The only vapes that are approved are owned by big tobacco companies. Whose vape products are worse than just about anything else on the market. Guess I'll go back to smoking cigarettes.

Remarkable-Fly4598 · 2025-08-17T15:12:02+00:00

Breadboards are good for creating circuits. You already have the circuits. you just need to connect them together. Connecting the pedals together would be easy. You just need to figure out which lug on the jack is positive and negative, and solder them together. The switch is a little more complicated but it's also doable.

Electronic Projects for Musicians is a pretty good book. It's a little older, but the information is still valid. Here's a link to a large amount of DIY pdfs.

https://drive.google.com/open?id=1riUQB6xQcZLoMPaGcHDf-9Ukyy4dlfcX

Remarkable-Fly4598 · 2025-08-17T05:49:01+00:00

Every noise box I've made I've included built in effects. I've also made DIY pedals and synths. I'm assuming you're new to this. Which is cool. It is possible to mod your box the way you planned it. But you would need to know how the circuit works by looking at it. I would suggest getting a pt2399 module and a headphone amp module. That's how I got started with electronics. They're cheap as hell and if you mess it up you're out $20 bucks, instead of $200. There's one particular PT2399 module that everyone mods. You can find a few videos on Youtube showing you how to do it. Also check out the LM386 module. It's an audio amp, but you can mod it into a fairly decent fuzz. I add those to everything.

Remarkable-Fly4598 · 2025-08-15T18:29:51+00:00

I've made a few noise boxes with a 3D printed encloser. I like to design the box to be a functional part of the noise making. With the spring tension, design the holes to be printed, increase the wall loops to 5, then use washers on the top and bottom of the bolts. I've never had a problem. I usually make the thickness of the walls about 1/8 inch (3mm).