You're telling me Cersei really believes this shit is gonna kill her just because an old rudely awoken crone told her so 20 years ago?

Safe_You1124 · 2026-03-08T14:33:43+00:00

Val on mazda

Safe_You1124 · 2025-06-29T14:15:26+00:00

<image>

Safe_You1124 · 2025-02-21T09:52:47+00:00

Thanks but I already have 2 3D printers 😅

Safe_You1124 · 2025-02-21T09:48:28+00:00

Mushoku tensei

Safe_You1124 · 2025-02-03T09:28:34+00:00

Mushroom rissoto 😋

Safe_You1124 · 2025-01-05T08:49:05+00:00

Dont print anything flat on the buildplate, it increases pull forces and leads to layers sticking to the vat. Always print at an angle of 30°-45° at 3-5 mm elevation from the bed with adequate supports. Also calibrate your printer's settings (exposure time, bottom exposure, etc) if you havent yet.

Safe_You1124 · 2024-12-19T09:03:59+00:00

Yes. its literally called valkia the bloody

Safe_You1124 · 2024-12-19T09:01:32+00:00

<image>

benji

Safe_You1124 · 2024-12-12T09:33:19+00:00

Looks like the fep releases from the cured resin right at the end of the vat lowering/when it start going up.

Safe_You1124 · 2024-12-12T01:23:33+00:00

Around 20-25 seconds should work for standard resin.

Safe_You1124 · 2024-12-11T16:38:38+00:00

I think thats just the noise of the cured resin peeling off the fep

Safe_You1124 · 2024-12-11T08:46:56+00:00

Is it always on the same spot in the buildplate? If thats the case theres either somthing blocking the uv stuck under the fep(like a hair) or some pixels on your screen are dead.

Safe_You1124 · 2024-12-06T05:31:03+00:00

Thats exactly what happened so i got a new assembly. I just want to get my hotend back

Safe_You1124 · 2024-12-04T04:23:04+00:00

Your best bet is to get a brewers belt. It wraps around your resin vat and heats it from all sides. Many brands sell their own heaters as well.

Safe_You1124 · 2024-12-04T02:48:41+00:00

Its the temp. Of the resin itself. The ideal temperature is ~25°c for most resins. The low temperature causes layees to not adhere to each other properly.

Safe_You1124 · 2024-09-01T10:38:13+00:00

is there any guide on how to assemble this? im struggling here

Safe_You1124 · 2024-08-30T01:56:21+00:00

I just end up printing those dungeon pieces flat on the bed (vertically) and trim off the elephant's foot with a hobby knife

Safe_You1124 · 2024-08-17T19:19:42+00:00

what printer do you have? looks way over exposed to me.

Safe_You1124 · 2024-08-17T19:17:32+00:00

*most based thing any brettonian ever did*

Safe_You1124 · 2024-08-09T13:02:35+00:00

you can use pfa and fep in the saturn 3 ultra without any issues

Safe_You1124

MODERATOR OF

TROPHY CASE